AAT1145_08 Datasheet, PDF (8/17 Pages) Advanced Analogic Technologies – 1.5A Step-Down Converter

SwitchReg^TM
Functional Block Diagram
PRODUCT DATASHEET
AAT1145
1.5A Step-Down Converter
OSC
0.6V
Softstart
OUT
EN
I_COMP
Over-Temperature
and Short-Circuit
Protection
R1*
R2*
V_IN
0.65V
OVDET
REF
0.6V
SHUTDOWN
SLOPE
COMP
SET
RESET
PWM
LOGIC
I_SENSE
AMP
NON-OVERLAP
CONTROL
I_ZERO
COMP
IN
V_IN 2.5V to 5.5V
LX
L1
C_OUT
PGND
V_OUT
R1*
R2*
AIN AGND
*The resistor divider R1 + R2 is internally set for the fixed output versions, and is externally set for the adjustable output versions.
Functional Description
The AAT1145 is a high output current monolithic switch-
mode step-down DC-DC converter. The device operates
at a fixed 1.2MHz switching frequency, and uses a slope
compensated current mode architecture. This step-down
DC-DC converter can supply up to 1500mA output cur-
rent at V_IN = 3.6V and has an input voltage range from
2.5V to 5.5V. It minimizes external component size and
optimizes efficiency at the heavy load range. The slope
compensation allows the device to remain stable over a
wider range of inductor values so that smaller values
(1μH to 4.7μH) with lower DCR can be used to achieve
higher efficiency. Apart from the small bypass input
capacitor, only a small L-C filter is required at the output.
The fixed output version requires only three external
power components (C_IN, C_OUT, and L). The adjustable ver-
sion can be programmed with external feedback to any
voltage, ranging from 0.6V to near the input voltage. It
uses internal MOSFETs to achieve high efficiency and can
generate very low output voltages by using an internal
reference of 0.6V. At dropout, the converter duty cycle
increases to100% and the output voltage tracks the
input voltage minus the low R_DS(ON) drop of the P-channel
high-side MOSFET and the inductor DCR. The internal
error amplifier and compensation provides excellent
transient response, load and line regulation. Internal
soft start eliminates any output voltage overshoot when
the enable or the input voltage is applied.
Current Mode PWM Control
Slope compensated current mode PWM control provides
stable switching and cycle-by-cycle current limit for
excellent load and line response with protection of the
internal main switch (P-channel MOSFET) and synchro-
nous rectifier (N-channel MOSFET). During normal
operation, the internal P-channel MOSFET is turned on
for a specified time to ramp the inductor current at each
rising edge of the internal oscillator, and switched off
when the peak inductor current is above the error volt-
age. The current comparator, I_COMP, limits the peak
inductor current. When the main switch is off, the syn-
chronous rectifier turns on immediately and stays on
8
www.analogictech.com
1145.2008.01.1.2