English
Language : 

AAT3601_08 Datasheet, PDF (30/37 Pages) Advanced Analogic Technologies – Total Power Solution for Portable Applications
PRODUCT DATASHEET
AAT3601178
Total Power Solution for Portable Applications
Input/Output Capacitors
The LDO regulator output has been specifically optimized
to function with low cost, low ESR ceramic capacitors.
However, the design will allow for operation over a wide
range of capacitor types. The input capacitor is shared
with all LDO inputs and the step-down converter. A 10μF
ceramic output capacitor is recommended for LDO2-5
and a 22μF is recommended for LDO1.
Current Limit and
Over-Temperature Protection
The regulator comes with complete short circuit and ther-
mal protection. The combination of these two internal
protection circuits gives a comprehensive safety system
to guard against extreme adverse operating conditions.
I2C Serial Interface
and Programmability
Serial Interface
Many of the features of the AAT3601 can be controlled via
the I2C serial interface. The I2C serial interface is a wide-
ly used interface where it requires a master to initiate all
the communications with the slave devices. The I2C pro-
tocol consists of 2 active wire SDA (serial data line) and
SCL (serial clock line). Both wires are open drain and
require an external pull up resistor to VCC (SYSOUT may
be used as VCC). The SDA pin serves I/O function, and the
SCL pin controls and references the I2C bus. I2C protocol
is a bidirectional bus which allows both read and write
actions to take place, but the AAT3601 supports the write
protocol only. Since the protocol has a dedicated bit for
Read or Write access (R/W), when communicating with
AAT3601, this bit must be set to “0”.
The timing diagram below depicts the transmission
protocol.
START MSB
Chip
Address
ACK from slave
LSB W ACK MSB
Register
Address
ACK from slave
LSB ACK MSB
Data
SCL
SDA
10011000
including R/W bit,
Chip Address = 0x98
Figure 9: I2C Timing Diagram.
ACK from slave
LSB ACK STOP
30
www.analogictech.com
3601.2008.07.1.1