AAT2552 Datasheet, PDF (2/33 Pages) Advanced Analogic Technologies – Total Power Solution for Portable Applications

AAT2552
Total Power Solution for Portable Applications
Pin Descriptions
Pin # Symbol
1
EN_BAT
2
ISET
3
AGND
4
FBB
5
ENB
6
MODE
7
ENA
8
FBA
9
OUTA
10
INA
11
INB
12
LX
13
PGND
14
BAT
15
ADP
16
STAT
EP
Function
Enable pin for the battery charger. When connected to logic low, the battery charger is dis-
abled and consumes less than 1µA of current. When connected to logic high, the charger
operates normally (pulled down internally).
Charge current set point. Connect a resistor from this pin to ground. Refer to typical charac-
teristics curves for resistor selection.
Analog ground.
Feedback input for the step-down converter. This pin must be connected directly to an exter-
nal resistor divider. Nominal voltage is 0.6V.
Enable pin for the step-down converter. When connected to logic low, the step-down convert-
er is disabled and consumes less than 1µA of current. When connected to logic high, the con-
verter operates normally (pulled up internally).
Pulled down internally for automatic PWM/LL operation. Connect to logic high for forced PWM.
Drive with external clock signal to synchronize step-down converter to external clock in PWM
mode.
Enable pin for the linear regulator. When connected to logic low, the regulator is disabled and
consumes less than 1µA of current. When connected to logic high, the LDO operates normal-
ly (pulled up internally).
Feedback input for the LDO. This pin must be connected directly to an external resistor divider.
Nominal voltage is 1.24V.
Linear regulator output. Connect a 2.2µF capacitor from this pin to ground.
Linear regulator input voltage. Connect a 1µF or greater capacitor from this pin to ground.
Input voltage for the step-down converter.
Output of the step-down converter. Connect the inductor to this pin. Internally, it is connected
to the drain of both high- and low-side MOSFETs.
Power ground.
Battery charging and sensing. Connect to positive terminal of Lithium-ion/polymer battery.
Input from USB port or AC wall adapter.
Open drain status pin for charger.
Exposed paddle (bottom): connect to ground directly beneath the package.
Pin Configuration
2
TDFN34-16
(Top View)
EN_BAT ¹
ISET ²
AGND ³
FBB ⁴
ENB ⁵
MODE ⁶
ENA ⁷
FBA ⁸
16 _STAT
15 _ADP
14 _BAT
13 _PGND
12 _LX
11 INB
10 _INA
9 _OUTA
2552.2007.04.1.0