AAT4650_06 Datasheet, PDF (1/14 Pages) Advanced Analogic Technologies – 5V/3V PC Card Power Switch

General Description
The AAT4650 SmartSwitch is a single channel PC
card (PCMCIA) power switch. It is used to select
between two different voltage inputs, each between
2.7V and 5.5V. An internal switch powers the cir-
cuitry from whichever input voltage is higher. The
device's output, V_CC, is slew rate controlled and cur-
rent limited, in compliance with PC card specifica-
tions. The current limit response time to a short cir-
cuit is typically 1µs. The internal P-channel MOSFET
switches are configured to break before make; that
is, both switches cannot be closed at the same time.
Controlled by a 2-bit parallel interface, the four states
for V_CC are V_CC5, V_CC3, high impedance, or ground.
When in the ground state, V_CC is pulled to ground by
a 5kΩ resistor. An open drain FAULT output is
asserted during over-current conditions. During
power-up slewing, FAULT also signals that V_CC is out
of tolerance. An internal over-temperature sensor
forces V_CC to a high impedance state when an over-
temperature condition exists. Quiescent current is
typically a low 15µA, as long as I_CC is less than
approximately 500mA. Above this load current, the
quiescent current increases to 200µA.
The AAT4650 is available in a Pb-free, 8-pin SOP
or TSSOP package and is specified over the -40°C
to +85°C temperature range.
Typical Application
AAT4650
5V/3V PC Card Power Switch
Features
SmartSwitch^™
• 2.7V to 5.5V Input Voltage Range
• 80mΩ (5V) Typical R_DS(ON)
• Low Quiescent Current 15µA (typ)
• Reverse-Blocking Switches
• Short-Circuit Protection
• Over-Temperature Protection
• FAULT Flag Output
• Temperature Range: -40°C to +85°C
• 8-Pin SOP or TSSOP Package
Applications
• Notebook Computer
• PDA, Subnotebook
• Power Supply Multiplexer Circuit
V_CC5
V_CC3
CIN5
1μF
GND
CTL1
CTL0
FAULT
CIN3
1μF
8 _VCC5
5 _VCC3
3 _CTL1
2 _CTL0
AAT4650
VCC ^6,7
4 _FAULT
1 _GND
COUT
0.1μF
V_CC
GND
4650.2006.05.1.2
1