English
Language : 

TMD27721 Datasheet, PDF (6/35 Pages) TEXAS ADVANCED OPTOELECTRONIC SOLUTIONS – DIGITAL ALS and PROXIMITY MODULE
TMD2772
DIGITAL ALS
and PROXIMITY MODULE
TAOS147E − DECEMBER 2012
Proximity Characteristics, VDD = VLEDA = 3 V, TA = 255C, PEN = 1 (unless otherwise noted)
PARAMETER
TEST CONDITIONS
MIN TYP MAX UNIT
IDD
Supply current
LED On
LED On, PDRIVE = 0
3
mA
100
ILEDA
LEDA current (Note 1)
LED On, PDRIVE = 1
LED On, PDRIVE = 2
50
mA
25
PTIME ADC conversion steps
PTIME ADC conversion time
lid PTIME ADC counts per step
PPULSE LED pulses (Note 5)
LED On LED pulse width
a LED pulse period
Proximity response, no target
v (offset)
ill Prox count, 100-mm target
(Note 3)
LED On, PDRIVE = 3
PTIME = 0xFF ( = 1 conversion step)
PTIME = 0xFF ( = 1 conversion step)
PPULSE = 1, PDRIVE = 0
PPULSE = 2, PDRIVE = 0
PPULSE = 8, PDRIVE = 0, PGAIN = 4×, (Note 2)
73 mm × 83 mm, 90% reflective Kodak Gray Card,
PGAIN = 4×, PPULSE = 8, PDRIVE = 0, PTIME = 0xFF
(Note 4)
12.5
1
256 steps
2.58 2.73 2.9 ms
0
1023 counts
0
255 pulses
7.3
μs
16.0
μs
100
counts
450 520 590 counts
t NOTES: 1. Value is factory-adjusted to meet the Prox count specification. Considerable variation (relative to the typical value) is possible after
G s adjustment.
2. Proximity offset varies with power supply characteristics and noise.
A t 3. ILEDA is factory calibrated to achieve this specification. Offset and crosstalk directly sum with this value and is system dependent.
4. No glass or aperture above the module. Tested value is the average of 5 consecutive readings.
5. These parameters are ensured by design and characterization and are not 100% tested.
s n 6. Proximity test was done using the following circuit. See the Application Information: Hardware section for recommended
application circuit.
m te VDD
a on 1mF
VDD 1
3
GND
TMD2772
4 LEDA
5 LEDK
6 LDR
1 mF 22 mF
l c IR LED Characteristics, VDD = 3 V, TA = 255C
a PARAMETER
TEST CONDITIONS
ic VF Forward Voltage
VR Reverse Voltage
PO Radiant Power
n λp Peak Wavelength
h Δλ Spectral Radiation Bandwidth
TR Optical Rise Time
Tec TF Optical Fall Time
IF = 20 mA
IR = 10 μA
IF = 20 mA
IF = 20 mA
IF = 20 mA
IF = 100 mA, TW = 125 ns, duty cycle = 25%
IF = 100 mA, TW = 125 ns, duty cycle = 25%
MIN TYP
1.4
5
4.5
850
40
20
20
MAX
1.5
40
40
UNIT
V
V
mW
nm
nm
ns
ns
The LUMENOLOGY r Company
r
r
www.taosinc.com
Copyright E 2012, TAOS Inc.
5