DSX2558 Datasheet, PDF (3/8 Pages) Amphenol Corporation – RF Mesh Networking technology provides reliable real time process data. Uses global 2.4 GHz RF frequencies

Interference
The SmartMesh^® technology combines frequency
hopping with TDMA (Time Division Multiple Access). In
addition the mesh protocol permits the system to learn
about the RF environment and dynamically adjust the
network parameters to best fit the current situation.
The network provides an accurate time reference for
the whole network, ensuring all loggers and the base
station are time synchronized correctly. Each data
sample is timestamped with this network time.
Real time graphing calculations
Real time graphing provides min/max/avg calculations
for the RH and Temp parameters of all the loggers
being plotted in the real time graph.
Alarming
User can set low and high alarms on the real time
graph to see if any loggers have crossed the limits. The
limits can also be labeled by the user.
Auto Calibration/Verification
Coexistence with Other RF Systems
The RF ValProbe complies with the IEEE 802.15.4, the
preeminent RF sensor network standard. Features like
frequency hopping, listen-before-you-talk and channel
blacklisting prevents other RF networks being affected
by the RF ValProbe.
Software Features
RF ValProbe System enables auto calibration/
verification for the users when using the RF loggers,
Kaye IRTD, Kaye Temperature baths. This enables the
user to select the set points and let the software run
the calibration/verification including loading of offsets
into the loggers automatically.
The software will control the Kaye drywells and read
the reference temperature data from a connected
Kaye IRTD permitting full automatic calibration with
the Kaye calibration products. Providing that the
users configure the communications port , access to
automatic calibration will be permitted. Calibration is
still permitted if either drywells or IRTD is not present,
in which case either semi-automatic or manual mode
calibration is used.
Historical graphing
Once a study has been started, user can connect his
PC anytime to the base station and retrieve all the data
from the base station on the real time graph to view the
data that has been logged by the loggers to that point.
This will enable viewing historical data without having
to stop the study at the base station.
RF Map
Independent Report Wizard
Along with the RF ValProbe software, there is an
additional software program called the “Kaye Report
Wizard”. This report wizard permits the user to launch
the “Create Reports” section independently of the
Kaye product installed on the user’s PC. The “Create
Reports” button of the standard software will continue
to operate as in previous versions. The user can decide
install the Report Wizard in a separate folder and use it
to report on all 3 Kaye products: Validator, Valprobe or
RF Valprobe.
Users can graphically view the RF Signal strength of
the loggers and their connections to other loggers and
basestation for stronger RF networks. A background
image can also be set for the RF map to position the
loggers on a real floor plan. The users can use this as
back up documentation for looking at the position of
the loggers at a later time.
3