English
Language : 

AMIS-52000 Datasheet, PDF (1/15 Pages) AMI SEMICONDUCTOR – Single-Chip Radio Transceiver
AMIS-52000 Single-Chip Radio Transceiver
Data Sheet
1.0 Introduction
The AMIS-52000 is a low cost, ultra low power ASK/OOK
(Amplitude Shift Keying/On-Off Shift Keying) transceiver
intended for narrow band RF applications. The device is
targeted for applications at 433MHz but can operate from
260 to 700MHz. The adjustable RF output ranges from –26
to +6dBm into a matched 50ohm load. The receiver
contains two independent receive channels which can be
2.0 Key Features
• Very low power single-chip transceiver
• Minimal external components
• Low power RC oscillator
• Unique Quick Start, low-noise oscillator (patent pending)
• Extreme low power RF Sniff Mode™, wake on RSSI
• Internal trim functions
connected to separate antennas for antenna diversity
applications.
On chip trim registers eliminate manual trimming of
external components. Using the on chip trimming, transmit
and receive frequencies achieve 5ppm accuracy over the
entire voltage and temperature range.
• I2C control interface
• Serial TX/RX data port
• Clock generation for an external microprocessor
• Wake up on RSSI
• Unique antenna diversity dual receiver (patent pending)
• Internal VCO/PLL tuning varactor
3.0 Technical Features
• Operating Frequency: Range 260 to 700MHz
• TX Output Power: +6dBm
• RX Sensitivity:
• Sniff Mode: -93dBm minimum
• Receive: -103dBm minimum @ 1Kbps
• Data Rate: 1 to 19.2Kbps, user selectable
• Power Requirements:
• Receive: 7.5mA (continuous)
• Transmit: 25mA full power; 50% duty cycle
• Sniff Mode: 750µA at a 1ms sniff rate (10% duty
cycle)
• Standby: 500nA (RC oscillator running)
• Operating Voltage: 2.4 to 3.6V
• Modulation: ASK/OOK (Amplitude Shift Key/On-Off
Shift Key)
• Xtal Start Time: 15µs (Quick Start)
• Sniff Mode Polling: 0.5ms to 16s (0.5ms or 64ms steps)
• PLL Lock Time: <50µs
• Selectable Data Filter: up to 19.2 Kbps
• Internal Trim Function:
• TX power
• Antenna for trim or tune (2 inputs are
independent)
• Xtal for frequency and quick start
• RC for frequency
• Sniff mode for data threshold
• Data slice
• I2C Interface: Control bus
• Serial Interface: Data input/output
• Low Frequency IF
• Internal IF Filtering
• Package: 20-lead, 209 m SSOP
AMI Semiconductor - Confidential
www.amis.com
1