AS4C16M16MD1 Datasheet, PDF (17/55 Pages) Alliance Semiconductor Corporation – Programmable output buffer driver strength

AS4C16M16MD1
256Mb MOBILE DDR SDRAM
CKEn-1 CKEn CURRENT STATE
COMMANDn
ACTIONn
NOTES
L
L
Power Down
X
Maintain Power Down
L
L
Self Refresh
X
Maintain Self Refresh
L
L
Deep Power Down
X
Maintain Deep Power Down
L
H
Power Down
NOP or DESELECT
Exit Power Down
5, 6, 9
L
H
Self Refresh
NOP or DESELECT
Exit Self Refresh
5, 7, 10
L
H
Deep Power Down
NOP or DESELECT
Exit Deep Power Down
5, 8
H
L
All Banks Idle
NOP or DESELECT
Precharge Power Down Entry
5
H
L
Bank(s) Active
NOP or DESELECT
Active Power Down Entry
5
H
L
All Banks Idle
AUTO REFRESH
Self Refresh Entry
H
L
All Banks Idle
BURST TERMINATE
Enter Deep Power Down
H
H
See the other Truth Tables
Table 7 – Truth Table - CKE [Notes 1 - 10]
Notes:
1. CKEn is the logic state of CKE at clock edge n; CKEn-1 was the state of CKE at the previous clock edge.
2. Current state is the state of Mobile DDR SDRAM immediately prior to clock edge n.
3. COMMANDn is the command registered at clock edge n, and ACTIONn is the result of COMMANDn.
4. All states and sequences not shown are illegal or reserved.
5. DESELECT and NOP are functionally interchangeable.
6. Power Down exit time (tXP) should elapse before a command other than NOP or DESELECT is issued.
7. SELF REFRESH exit time (tXSR) should elapse before a command other than NOP or DESELECT is issued.
8. The Deep Power-Down exit procedure must be followed as discussed in the Deep Power-Down section of the Functional
Description.
9. The clock must toggle at least once during the tXP period.
10. The clock must toggle at least once during the tXSR time.
Basic Timing Parameters for Commands
Figure.6 — Basic Timing Parameters
- 17 -
Mar, 28, 2013