|
AKD4113-B Datasheet, PDF (8/21 Pages) Asahi Kasei Microsystems – 192kHz digital audio receiver | |||
|
◁ |
ASAHI KASEI
[AKD4113-B]
Control Software Manual
 Set-up of evaluation board and control software
1. Set up the AKD4113-B according to previous term.
2. Connect IBM-AT compatible PC with AKD4113-B by 10-line type flat cable (packed with AKD4113-B). Take care
of the direction of 10pin header. (Please install the driver in the CD-ROM when this control software is used on
Windows 2000/XP. Please refer âInstallation Manual of Control Software Driver by AKM device control softwareâ.
In case of Windows95/98/ME, this installation is not needed. This control software does not operate on Windows
NT.)
3. Insert the CD-ROM labeled âAKD4113-B Evaluation Kitâ into the CD-ROM drive.
4. Access the CD-ROM drive and double-click the icon of âakd4113-b0.exeâ to set up the control program.
5. Then please evaluate according to the follows.
 Operation flow
Keep the following flow.
1. Set up the control program according to explanation above.
2. Click âWrite defaultâ button.
3. Then set up the dialog and input data.
 Explanation of each buttons
1. [Port Setup] :
Set up the printer port.
2. [Write default] : Initialize the register of AK4113.
3. [All Write] :
Write all registers that is currently displayed.
4. [Read All] :
All the registers of AK4113 are read.
5. [Function1] :
Dialog to write data by keyboard operation.
6. [F3] :
Dialog of sequential writing.
7. [SAVE] :
Save the current register setting.
8. [OPEN] :
Write the saved values to all register.
9. [Write] :
Dialog to write data by mouse operation.
10. [Read] :
The data corresponding to each register is read.
<KM076501>
-8-
2004/11
|
▷ |