AKD4213-B Datasheet, PDF (7/35 Pages) Asahi Kasei Microsystems – AK4213 Evaluation Board Rev.1

[AKD4213-B]
Control Software Manual
„ Set-up of evaluation board and control software
1. Set up the AKD4213-B according to the content of the preceding pages.
2. Connect IBM-AT compatible PC with AKD4213-B by USB interface board (packed with AKD4213-B). Take care
of the direction of 10pin header. (Please install the driver in the CD-ROM when this control software is used on
Windows 2000/XP. Please refer “Installation Manual of Control Software Driver by AKM device control software”.
In case of Windows95/98/ME, this installation is not needed. This control software does not operate on Windows
NT.)
3. Insert the CD-ROM labeled “AKD4213-B Evaluation Kit” into the CD-ROM drive.
4. Access the CD-ROM drive and double-click the icon of “akd4213.exe” to set up the control program.
5. Operate the software according to the followings.
„ Operation flow
Keep the following flow.
1. Set up the control program according to explanation above.
2. Click “Port Reset” button.
3. Click “Write default” button
„ Explanation of each buttons
1. [Port Reset] :
2. [Write default] :
3. [All Write] :
4. [Function1] :
5. [Function2] :
6. [Function3] :
7. [Function4] :
8. [Function5]:
9. [SAVE] :
10. [OPEN] :
11. [Write] :
Set up the USB interface board (AKDUSBIF-A) when using the board.
Initialize the register of the AK4213.
Write all registers that is currently displayed.
Dialog to write data by keyboard operation.
Dialog to write data by keyboard operation.
The sequence of register setting can be set and executed.
The sequence that is created on [Function3] can be assigned to buttons and executed.
The register setting that is created by [SAVE] function on main window can be assigned to
buttons and executed.
Save the current register setting.
Write the saved values to all register.
Dialog to write data by mouse operation.
„ Indication of data
Input data is indicated on the register map. Red letter indicates “H” or “1” and blue one indicates “L” or “0”. Blank is the
part that is not defined in the datasheet.
<KM092201>
-7-
2008/04