AKD5365 Datasheet, PDF (6/27 Pages) Asahi Kasei Microsystems – Evaluation board Rev.A for AK5365

ASAHI KASEI
[AKD5365]
The cut-off frequency of the input circuit on this evaluation board is as below. When changing the cut-off frequency,
change the constant of the each resistor and capacitor.
(1) The cut-off frequency of HPF in front of the Pre-Amp : fc = 3.4Hz (R = 47kΩ, C = 1µF)
(2) The cut-off frequency of HPF, which is composed by the input resistance of the IPGAL/R pins and the capacitor
of between the Pre-Amp output and the IPGA input : fc = 3.4Hz. (R = 10kΩ, C = 4.7µF)
(2) Output Circuit
Signal of LOUT and ROUT pins are output via J3 (LOUT) and J6 (ROUT).
LOUT
R20
J3
220
LOUT
C22
22u
R21
47k
ROUT
R22
J6
220
ROUT
C25
22u
R23
47k
Figure 4. LOUT/ROUT Output circuits
* AKM assumes no responsibility for the trouble when using the circuit examples.
<KM068900>
-6-
2002/04