|
AK5572EN Datasheet, PDF (53/68 Pages) Asahi Kasei Microsystems – 2-Channel Differential 32-bit ADC | |||
|
◁ |
[AK5572]
â Power Down Function/ Sequence
The AK5572 enters power-down mode by setting the PDN pin to âLâ. Digital filters are reset at the same
time.
[1] PCM Mode
In slave mode, internal power down signal (Internal PDN) is released by inputting MCLK, BICK and
LRCK after setting the PDN pin to âHâ. In master mode, The Internal PDN is released by inputting
MCLK after setting the PDN pin to âHâ.
Initialization cycle starts when the Internal PDN is released. The output data of SDTO will be valid in
583 ï´ 1/fs after exiting power-down mode in slave mode, it will be valid in 578 ï´ 1/fs after exiting
power-down mode in master mode. During initialization, the ADC digital outputs of both channels are in
2âs complement format and forced to â0â. The ADC outputs settle to data correspondent to the input
signals after the end of initialization. This settling takes approximately the group delay time.
Power
PDN pin
(1)
VDD18 pin
Internal PDN
(2)
Internal
State
Power -down
(3)
Initialize
Normal Operation
Power -down
ADC In
(Analog)
ADC Out
(Digital)
Clock In
Donât care
MCLK,LRCK,BICK
(4)
â0âdata
Idle Noise
(5)
GD
(5)
GD
Idle Noise
(4)
â0âdata
(6)
Donât care
Figure 59. Power-Up/Down Sequence Example
Notes:
(1) The PDN pin should be held to âLâ for more than 150 ns after AVDD and TVDD are powered up.
(2) a. LDEO pin = âHâ, I2C pin = âHâ and PSN pin = âHâ (Parallel Mode):
The internal LDO is powered up by releasing PDN pin to âHâ. The Internal PDN is released by
toggling MCLK for 16384times.
b. LDOE pin = âHâ and PSN pin = âLâ (Register Mode):
The internal LDO is powered up by releasing PDN pin to âHâ. The internal PDN is released by
toggling internal oscillator clock for 16384 times (max. 10 ms).
c. LDOE pin = âLâ:
The internal PDN is released in 1 ms (max.) after releasing PDN pin to âHâ.
During this period, digital output and digital in/output pins may output an instantaneous pulse (max. 1
us). Therefore, referring the output of digital pins and data transmission with a device on the same
3-wire serial/I2C bus as the AK5572 should be avoided in this period to prevent system errors.
015016766-E-00
- 53 -
2015/12
|
▷ |