AK4710 Datasheet, PDF (5/31 Pages) Asahi Kasei Microsystems – Low Power Single SCART Driver

[AK4710]
Negative Voltage Output Pin
Connect to VSS2 with a 1.0μF capacitor that should have the low ESR (Equivalent
26 VEE
O
Series Resistance) over all temperature range. When this capacitor has the polarity,
the positive polarity pin should be connected to the VSS2 pin. Non polarity
capacitors can also be used.
Negative Charge Pump Capacitor Terminal Pin
Connect to CP with a 1.0μF capacitor that should have the low ESR (Equivalent
27 CN
I Series Resistance) over all temperature range. When this capacitor has the polarity,
the positive polarity pin should be connected to the CP pin. Non polarity capacitors
can also be used.
Positive Charge Pump Capacitor Terminal Pin
Connect to CN with a 1.0μF capacitor that should have the low ESR (Equivalent
28 CP
I Series Resistance) over all temperature range. When this capacitor has the polarity,
the positive polarity pin should be connected to the CP pin. Non polarity capacitors
can also be used.
29 VSS2
- Charge Pump Ground Pin , 0V
Charge Pump Power Supply Pin: 3.13V ~ 3.47V
30 VD2
- Normally connected to VSS2 with a 0.1μF ceramic capacitor in parallel with a 4.7μF
electrolytic cap.
31 SCL
I Control Data Clock Pin
32 SDA
I/O Control Data Pin
Note: All digital input pins should not be left floating.
Rev. 0.3
2011/07
-5-