AKD4396 Datasheet, PDF (3/30 Pages) Asahi Kasei Microsystems – Evaluation board

ASAHI KASEI
[AKD4396-SBW]
„ Evaluation mode
1. DIR(COAX) (default)
J1 is used for the evaluation using such as CD test disk. The DIR generates MCLK, BICK and LRCK SDATA from the
received data through BNC connector (J1). Setting of jumper is shown below.
COAX is recommended for an evaluation of the Sound quality.
JP1
OPT
COAX
BNC
(Default)
Figure 2 Jumper setting, when using DIR
2. DIR(Optical Link)
PORT1 is used for the evaluation using such as CD test disk. The DIR generates MCLK, BICK and LRCK SDATA from the
received data through optical connector (PORT2: TORX176). Setting of jumper is shown below.
JP1
OPT
COAX
PORT2
Figure 3 Jumper setting, when using DIR
3. All clocks are fed through the PORT1.
-R9, R12, R13, R14 : open
-R10, R15, R19, R20 : 100Ω or short (0 Ω)
„ DIP Switch setting
[SW2]: AK4113 setting
No.
Pin
OFF
ON
1
OCKS1 AK4113 Master Clock setting
2
OCKS0 ^{Refer to Table4}
Table 2 SW2 setting
[SW3]: AK4396 setting
No.
Pin
OFF
ON
1
2
P/S
Serial mode (Note)
Parallel mode
Note : When using the serial mode, R5 and R17 should be removed.
Table 3 SW3 setting
Default
ON
OFF
Default
-
ON
<KM078101>
3
2005/03