AKD4396 Datasheet, PDF (2/30 Pages) Asahi Kasei Microsystems – Evaluation board

ASAHI KASEI
[AKD4396-SBW]
„ Operation sequence
1) Set up the power supply lines. (See “Other jumpers set-up”.)
Name
Color
Voltage
Comments
Attention
+15V
-15V
AGND
Red
Blue
Black
+12∼+15V
-12∼-15V
0V
Regulator,
Power supply for Op-amp.
Regulator,
Power supply for Op-amp.
GND
This jack is always needed. Power line
This jack is always needed. Power line
This jack is always needed.
Table 1 Set up of power supply lines
Each supply line should be distributed from the power supply unit.
2) Set-up the jumper pins
3) Set-up the DIP switches. (See the followings.)
4) Power on
The AK4396 should be reset once bringing SW1 (PDN) “L” upon power-up.
<KM078101>
2
2005/03