|
AK4346 Datasheet, PDF (3/31 Pages) Asahi Kasei Microsystems – 3.3V 192kHz 24-Bit 6-Channel DAC | |||
|
◁ |
ASAHI KASEI
[AK4346]
PIN/FUNCTION
No. Pin Name
I/O Function
1 MCLK
I Master Clock Input
An external TTL clock should be input on this pin.
2 BICK
I Audio Serial Data Clock
3 SDTI1
I DAC1 Audio Serial Data Input
4 LRCK
I L/R Clock
5 RSTB
I Reset Mode
When at âLâ, the AK4346 is in reset mode.
The AK4346 must be reset once upon power-up.
6 SMUTE
I Soft Mute in parallel control mode
âHâ: Enable, âLâ: Disable
CSN
I Chip Select in serial 3-wire mode
CAD0
I Chip Address in serial I2C mode
7 ACKS
I Auto Setting Mode in parallel control mode
âLâ: Manual Setting Mode, âHâ: Auto Setting Mode
CCLK
I Control Data Clock in serial 3-wire control mode
SCL
Control Data Clock in serial I2C control mode
8 DIF0
I Audio Data Interface Format in parallel control mode
CDTI
I Control Data Input in serial 3-wire control mode
SDA
I/O Control Data in serial I2C control mode
9 SDTI2
I DAC2 Audio Serial Data Input
10 SDTI3
I DAC3 Audio Serial Data Input
11 TST1
I Test pin â connect to ground.
12 DIF1
I Audio Data Interface Format
13 CAD1
I Chip Address in serial control mode
DEM0
I De-emphasis Filter Enable
14 DVDD
Digital Power Supply, +2.7â¼+3.6V
15 DVSS
Digital Ground
16 I2C
I µP I/F Mode Select in serial control mode
âLâ: 3-wire Serial, âHâ: I2C Bus
DEM1
I De-emphasis Filter Enable in parallel control mode
17 TST2
- Test pin â leave this pin floating.
18 TST3
- Test pin â leave this pin floating.
19 ROUT3
O DAC3 Right Channel Analog Output
20 LOUT3
O DAC3 Left Channel Analog Output
21 ROUT2
O DAC2 Right Channel Analog Output
22 LOUT2
O DAC2 Left Channel Analog Output
23 P/S
I Parallel/Serial Control Mode Select
(Internal pull-up pin)
âLâ: Serial control mode, âHâ: Parallel control mode
24 ROUT1
O DAC1 Right Channel Analog Output
25 LOUT1
O DAC1 Left Channel Analog Output
26 VCOM
O Common Voltage, AVDD/2
Normally connected to AVSS with a 0.1µF ceramic capacitor in parallel with a
10µF electrolytic cap.
27 AVSS
- Analog Ground
28 AVDD
- Analog Power Supply, +2.7â¼+3.6V
29 TDM0
I TDM I/F Format Mode in parallel control mode (Internal pull-down pin)
âLâ: Normal mode, âHâ: TDM 256 mode
DZF2
O Data Zero Input Detect in serial control mode
30 DZF1
O Data Zero Input Detect
Note: All input pins except P/S and TDM0 pins should not be left floating.
MS0531-E-00
-3-
2006/07
|
▷ |