AKD5373-A Datasheet, PDF (2/24 Pages) Asahi Kasei Microsystems – Evaluation board Rev.2 for AK5373

„ Outline Chart
GND
VDD3.3
J2
BOARD OUTLINE CHART
MCKI
USB1
PORT5
[AKD5373-A]
J3
PORT6
SW3
Figure 2. AKD5373-A top view
USB2
„ Comment
(1) VDD3.3V, GND
These are the power supply connectors. Connect power supply with these pins.
As for the detail comments, refer to the setup of power supply on the next page.
(2) MCKI (BNC-JACK)
This is external clock source for the MCKI/XTI pin of the AK5373.
(3) USB1 (USB Connector)
This is USB B-type connector for evaluation of the AK5373. Connect this to PC.
(4) USB2 (USB Connector)
This is USB B-type connector for EEP-ROM write operation.
(5) J2, J3 (Mini Jacks)
These are analog signal inputs.
(6) PORT5, PORT6 (10 pin header)
PORT5 (TEST PORT): It is not used except test mode
PORT6 (DSP): This is External serial audio interface. A/D data output and DSP data input are possible via this
port.
(7) SW3 (Switch)
SW3: Reset of AK5373. Keep “H” during normal operation.
[KM101503]
-2-
2010/08