English
Language : 

AKD4626 Datasheet, PDF (2/39 Pages) Asahi Kasei Microsystems – Evaluation board Rev.B for AK4626
ASAHI KASEI
[AKD4626]
n Operation sequence
(1) Set up the power supply lines.
[+12V] (orange jack) = +12 ∼ +15V
[-12V] (blue jack)
= -12 ∼ -15V
[AGND] (black jack) = 0V
[DGND] (black jack) = 0V
Each supply line should be distributed from the power supply unit.
±12V are supplied to analog interface.
+12V is regulated to +5V and +3.3V by regulators(T1,T2).
+5V is supplied to digital interface, AK4626 and TVDD of AK4112B.
+3.3V is supplied to AVDD and DVDD of AK4112B and TVDD of AK4626.
(2) Set up the evaluation mode and jumper pins. (See p.6.)
(3) Power on.
The AK4626, AK4112B and AK4103 should be reset once bringing PDN(SW1) “L” upon power-up.
(4) Set up software.
The control mode of AK4626 and AK4112B is fixed to “serial”.
PORT1
10 uP-I/F
9
CSN
The AKD4626 can be controlled via the printer port (parallel port) of IBM-AT
compatible PC. Connect PORT1(uP-I/F) with PC by 10-line flat cable
packed with the AKD4626.
CCLK
CDTI
CDTO
Take care of the direction of connector. There is a mark at pin#1.
The pin layout of PORT1 is as Figure 2.
2
1
Figure 2. PORT1 pin layout
<KM071600>
-2-
2003/4