|
AK2358F Datasheet, PDF (2/26 Pages) Asahi Kasei Microsystems – Base-band LSI for Europian Cordless Telephones(CTI, CTI+) | |||
|
◁ |
ASAHI KASEI
[AK2358FI
Base-band 1S1 for kopian Cordless Telephones(CTl, CT1+)
I
Features
I
â¢1 Meets to the specification of the europian cordless telephones (CT1, CT1+)
â¢1 Built-in voice filter for cordless telephone, MSK MODEM (2400bps), COMPANDOR, and
scrambler circuit
â¢1 Low / wide operation voltage range (1.9 V to 5.5V)
â¢1 Built-in COMPANDOR output transient response circuit and time constant circuit
â¢1 No external component is needed for COMPANDOR
â¢1 Built-in buffer amplifier for ceramic receiver driving.
â¢1 Built-in electronic volume for microphone sensitivity and modulator/demodulator
sensitivity
â¢1 Receiving level switchable in 8 steps (-12 to +9dB)
â¢1 Built-in u uting function for voice transmitting and receiving
â¢1 External adjustment for the limiter level
â¢1 Built-in amplifier for transmission and reception gain adjustment
â¢1 Low power CMOS and power-down function
u Built-in 3.58MHz oscillator circuit
â¢1 Scrambler circuit with frequency inversion. Two inversion frequencies can be
selected.
â¢1 Bypassing the scrambler circuit available
u Built-in frame detection function for the MSK demodulator
u Control register and MSK MODEM data buffer controlled by serial interface
â¢1 Few external component is necessary resulting cost reduction and small set size.
El Package: 24 pin VSOP
Block Diagram
I
IT Data/Rx Data
Control data
(
!rane d e t e c t i o n
Receiver
\ control register
i and data buffer
!4S1 MODEM
splatter f i lter
Transmission signal
output
3 .58NHz
Reception signal
input
0152 E 00
Eecept inn nutput
1996/12
|
▷ |