AKD4186-A Datasheet, PDF (12/19 Pages) Asahi Kasei Microsystems – Evaluation board Rev.1 for AK4186

■ Explanation of Draw Function
When clicks the “DRAW MODE”, the window as shown in Figure 6 opens.
[AKD4186-A]
Figure 6. Draw Function Window
1. Measurement Mode
[Averaging 6 data]: COUNT bit is set to “0” (6 times).
[Averaging 10 data]: COUNT bit is set to “1” (10 times).
[Software Algorithm]: Predict the movement before and after the measurement of the data based on Averaging (6
data), and invalidate the data out of range.
2. Panel Sensitivity
Please adjust panel sensitivity regarding to the Touch Screen.
3. Operation
[START]: Start scanning of the touch screen. The track that you drew on touch screen is shown on the scren.
Please adjust screen sensitivity to get smooth tracking.
The screen will be cleared when [START] button is clicked again.
[Paint/Locate]: When drawing on a touch screen, a track is shown on the screen if Paint is active.
When drawing on a touch screen, a mouse cursor moves on the screen if Locate is active.
(shortcut key: Ctrl)
[STOP]:
Stop the draw function.
[Pen Color]: Pen color using is shown. Select the color from a color panel on the touch screen to change the pen
color.
[Close]:
Close the Draw Function Window.
4. Record
A painting track can be recorded. After clicking the [START] button, pen touch is detected and a recording starts.
If Pen Up is detected, the recording finishes. The recorded file is saved as a time stamp name, without overwrite.
<KM095901>
- 12 -
2009/2