AT1305 Datasheet, PDF (11/13 Pages) Aimtron Technology – PFM Step-Up DC/DC Converter with LDO

AT1305
Preliminary Product Information
PFM Step-Up DC/DC Converter with LDO
Power good
The PG pin stays high impedance when the dc/dc converter or the LDO output
voltage high than 2.7 V, and falling down when the voltage low than 2.6V. It could be
used to enable the processor after the push-button start-up.
On/Off Control
A single pushbutton switch can be used to turn the AT1305 on and off. EN is pulled
low (internal) and /ENPB is pulled high when the AT1305 is off. When the switch is
pressed, /ENPB is pulled low and the IC turns on. The switch should be on long
enough for the processor to exit reset. The controller issues a logic high to EN, which
guarantees the IC will stay on regardless of the switch state.
EN
/ENPB
AT1305
0
0
ON
0
1
OFF
1
0
ON
1
1
ON
7F, No.9,PARK AVENUE. II, Science-Based Industrial Park, Hsinchu 300,Taiwan, R.O.C.
Tel: [phone] Fax: [phone]
WWW: http://www.aimtron.com.tw
2/8/2006 REV:1.1
Email: [e-mail]
11