AM100HB-UZ Datasheet, PDF (4/4 Pages) AIMTEC – 100 Watt | Half Brick DC-DC Converter

The SW can be replaced by a NPN transistor with connection as follows:
Series AM100HB-UZ
100 Watt | Half Brick DC-DC Converter
Output Voltage Trim connection:
The output voltage can be adjusted by connecting trim resistors as shown.
The values can be determined according to the following formulas where Δ% is the desirable voltage adjustment in percentage and Vo is
the Nominal value of the Output Voltage:
Vo(100+∆%) - (100+2∆%)
Rup =
1.225∆%
∆%
KΩ
100 – 2
Rdown =
∆%
KΩ
The calculated Resistor values are in KΩ.
NOTE: 1. Datasheets are updated as needed and as such, specifications are subject to change without notice. Once printed or downloaded, datasheets are no longer controlled
by Aimtec; refer to www.aimtec.com for the most current product specifications. 2. Product labels shown, including safety agency certifications on labels, may vary based on the
date manufactured. 3. Mechanical drawings and specifications are for reference only. 4. Aimtec may not have conducted destructive testing or chemical analysis on all internal
components and chemicals at the time of publishing this document. CAS numbers and other limited information are considered proprietary and may not be available for release.
5. This product is not designed for use in critical life support systems, equipment used in hazardous environments, nuclear control systems or other such applications which
necessitate specific safety and regulatory standards other the ones listed in this datasheet.
www.aimtec.com
F 054e R3.D
Tel: [phone]
4 of 4
Toll free: + 1 888 9 AIMTEC
(924 6832)
North America only