AM10EW-NZ Datasheet, PDF (3/3 Pages) AIMTEC – 10 Watt | DC-DC Converter

Recommended Circuit
Series AM10EW-NZ
10 Watt | DC-DC Converter
Vin+
C1
10 ~ 47µf
Vin-
Vo+
C2
Aimtec
10µf
DC/DC
Converter
Vo-
Note: Greater noise filtering can be achieved with additional
capacitors, however the largest size can not exceed maximum
capacitive load specification.
Parallel connections are not recommended.
Product does not support hot swap / plug and play configurations.
Derating
Free Air Convection
100
71ºC
80
60 ^{Safe Operating Area}
40
20
0
-40 -20
0
20
40
60
80 ⁸⁵ 100
Ambient Temperature º C
NOTE: 1. Datasheets are updated as needed and as such, specifications are subject to change without notice. Once printed or downloaded, datasheets are no longer controlled
by Aimtec; refer to www.aimtec.com for the most current product specifications. 2. Product labels shown, including safety agency certifications on labels, may vary based on the
date manufactured. 3. Mechanical drawings and specifications are for reference only. 4. All specifications are measured at an ambient temperature of 25°C, humidity<75%,
nominal input voltage and at rated output load unless otherwise specified. 5. Aimtec may not have conducted destructive testing or chemical analysis on all internal components
and chemicals at the time of publishing this document. CAS numbers and other limited information are considered proprietary and may not be available for release. 6. This
product is not designed for use in critical life support systems, equipment used in hazardous environments, nuclear control systems or other such applications which necessitate
specific safety and regulatory standards other the ones listed in this datasheet. 7. Warranty is in accordance with Aimtec’s standard Terms of Sale available at www.aimtec.com.
www.aimtec.com
F 051e R12.B
Tel: [phone]
3 of 3
Toll free: + 1 888 9 AIMTEC
(924 6832)
North America only