AM10CW-NZ Datasheet, PDF (3/3 Pages) AIMTEC – 10 Watt | DC-DC Converter

Pin Out Specifications
Pin
Single
Dual
1
+V Input
+V Input
2
-V Input
-V Input
3 On/Off Control On/Off Control
4
+V Output
+V Output
5
No pin
Common
6
-V Output
-V Output
Derating
100
80
Free Air Convection
65 ^ºC 3.3, 5V & ±5V models
71ºC Other models
Series AM10CW-NZ
10 Watt | DC-DC Converter
Dimensions
Top View
25.40
(1.00)
Bottom View
10.16
(0.40)
10.16
(0.40)
2.54
(0.10)
Side View
Printed Face
4
5
6
+V Output
-V Output
+V -V
Input Input _CTRL
12 3
10.16 5.08 ^7.62
(0.40) (0.20) ^(0.30)
60
Safe Operating Area
40
20
0
- 40 - 20 0
20
40
65 71
60
80
85
100
Ambient Temperature º C
2.54
(0.10)
ᴓ 1.00
(0.39)
Dimensions mm (inch)
Case Tolerance ±0.50 (±0.02)
Pin Diameter 1.0 ± 0.10 (0.04 ± 0.004)
Recommended EMC Circuits
F1
+Vin
MOV
‐Vin
LDM
4.7µH
C1
C2
MOV
C1
C2
C3
24V input
S14K35
330µF/50V
1µF/50V
10µF/50V
48V input
S14K60
330µF/100V
1µF/100V
10µF/100V
CY1
1nF/2KV
DC‐DC Converter
CY2
1nF/2KV
+Vo
C3
‐Vo
NOTE: 1. Datasheets are updated as needed and as such, specifications are subject to change without notice. Once printed or downloaded, datasheets are no longer controlled
by Aimtec; refer to www.aimtec.com for the most current product specifications. 2. Product labels shown, including safety agency certifications on labels, may vary based on the
date manufactured. 3. Mechanical drawings and specifications are for reference only. 4. All specifications are measured at an ambient temperature of 25°C, humidity<75%,
nominal input voltage and at rated output load unless otherwise specified. 5. Aimtec may not have conducted destructive testing or chemical analysis on all internal components
and chemicals at the time of publishing this document. CAS numbers and other limited information are considered proprietary and may not be available for release. 6. This
product is not designed for use in critical life support systems, equipment used in hazardous environments, nuclear control systems or other such applications which necessitate
specific safety and regulatory standards other the ones listed in this datasheet. 7. Warranty is in accordance with Aimtec’s standard Terms of Sale available at www.aimtec.com.
www.aimtec.com
F 051e R13
Tel: [phone]
3 of 3
Toll free: + 1 888 9 AIMTEC
(924 6832)
North America only