AMEPR30D-AZ_16 Datasheet, PDF (2/5 Pages) AIMTEC – AC-DC Constant current LED Driver

Series AMEPR30D-AZ
up to 2A | AC-DC LED driver
Output Specifications (continued)
Parameters
Conditions
Typical
Maximum
Ripple & Noise ^③
3
Hold-up time
1
Minimum Load Voltage
See the models table
③ _{Ripple and Noise are measured at 20MHz bandwidth by using a 0.1μF (M/C) or (C/C) and 47µF (E/C) parallel capacitor.}
Isolation Specifications
Parameters
Tested I/O voltage
Isolation Resistance
Conditions
60sec
Typical
>1000
Maximum
3000
Units
V p-p
ms
Units
VAC
MΩ
General Specifications
Parameters
Switching frequency
Over load protection
Over voltage protection
Short circuit protection
Over temperature protection
Operating temperature
Maximum case temperature
Storage temperature
Temperature coefficient
Cooling
Humidity
Case material
Wires
Weight
Dimensions (L X H X W)
MTBF
Conditions
Typical
Maximum
65
≧110
≧110
Auto recovery
>105°C
With derating over 55°C
-20 to +80
100
-40 to +95
±0.02
Free air convection
95
Plastic
UL1015 Input 18AWG*10CM/ Output 20 AWG * 10CM
200
133x33x30mm (5.24 x 1.30 x 1.18 inch)
>400,000 hrs (MIL-HDBK-217F at +25°C)
Units
KHz
%
%
o_C
o_C
o_C
% / ^oC
% RH
g
Environment Approval
Test
Parameters
Wave form
Acceleration amplitude
Shock
Bump duration
Converter operation
Number of bumps
Test mode
Vibration
Displacement
Acceleration
Converter operation
Conditions
Half sine wave
5gn
30 ms
Before and after test, body mounted (on chassis)
18 (3 in each direction for every axis)
Sweep sine, 10-100Hz, speed 0.05Hz/s
1 mm
3g, 3 loops 30min one cycle, 3h total, every axis tested
Before and after test, body mounted (on chassis)
Safety Specifications
Parameters
Agency approvals cULus, CE, FCC
EN61347-1, EN61347-2-13, IEC62384, UL8750, UL60950-1, EN55015, EN55024, FCC Part 15 Subpart B, Class
B, ANSI C63.4 :2003
Harmonic Current Emissions
IEC/EN 61000-3-2, Class C
Voltage fluctuations and flicker
IEC/EN 61000-3-3, (EN60555-3)
Electrostatic Discharge Immunity
IEC 61000-4-2 Level 3
Standards
RF, Electromagnetic Field Immunity
Electrical Fast Transient/Burst Immunity
IEC 61000-4-3 Level 2
IEC 61000-4-4 Level 2
Surge Immunity
IEC 61000-4-5 Level 2
RF, Conducted Disturbance Immunity
IEC 61000-4-6 Level 2
Power frequency Magnetic Field Immunity
IEC 61000-4-8 Level 2
Voltage dips, Short Interruptions Immunity
IEC 61000-4-11
www.aimtec.com
F 052.1e R3.S
Tel: [phone]
2 of 5
Toll free: + 1 888 9 AIMTEC
(924 6832)
North America only