UG-581 Datasheet, PDF (9/28 Pages) Analog Devices – Full-featured evaluation board

Evaluation Board User Guide
Figure 14. EVAL-SDP-CH1Z Drivers Setup Window 5
EVAL-AD7961FMCZ
LAUNCHING THE SOFTWARE
Once the EVAL-AD7961FMCZ and EVAL-SDP-CH1Z are
correctly connected to your PC, the AD7961 software can be
launched.
1. From the Start menu, select Programs>Analog Devices>
AD7960_61 Evaluation Software. The main window of
the software then displays (see Figure 19).
If the evaluation system is not connected to the USB port
via the EVAL-SDP-CH1Z when the software is launched, a
connectivity error displays (see Figure 17).
2. Connect the evaluation board to the USB port of the PC.
3. Wait for a few seconds and then click Rescan (see
Figure 18.
Figure 15. EVAL-SDP-CH1Z Drivers Setup Window 6
After installation is complete, connect the EVAL-AD7961FMCZ
to the EVAL-SDP-CH1Z as described in the Evaluation Board
Hardware section.
When you first plug in the EVAL-SDP-CH1Z board via the USB
cable provided, allow the new Found Hardware Wizard to run.
Once the drivers are installed, you can check that the board has
connected correctly by looking at the Device Manager of the
PC. The Device Manager can be accessed via
My Computer>Manage>Device Manager from the list of
System Tools. The EVAL-SDP-CH1Z board should appear
under ADI Development Tools.
This completes the installation.
Figure 17. Connectivity Error Alert 1
Figure 18. Connectivity Error Alert 2
Figure 16. Device Manager
Rev. 0 | Page 9 of 28