EVAL-AD5676SDZ Datasheet, PDF (8/12 Pages) Analog Devices – Full featured evaluation board

UG-814
EVAL-AD5676SDZ/EVAL-AD5676RSDZ User Guide
HOW TO USE THE SOFTWARE
STARTING THE SOFTWARE
To run the program, take the following steps:
1. Connect the evaluation board to the SDP-B board, and
connect the USB cable between the SDP-B board and
the PC.
2. Power the SDP-B board and the evaluation board by
connecting 6 V to Connector J3.
3. Click Start > All Programs > Analog Devices >
AD5676/AD5676R > AD5676/AD5676R Evaluation
Software. While the software connects to the evaluation
board, the message in Figure 3 displays.
Figure 3. Connection Message
If the SDP-B board is not connected to the USB port when the
software is launched, a connectivity error displays (see Figure 4).
Connect the evaluation board to the USB port of the PC, wait a
few seconds, click Rescan, and follow the instructions.
Figure 4. Connectivity Error
Alternatively, the software can be used without an evaluation
board. The software runs in simulation mode displaying
expected outputs based on the input data. The main window
of the AD5676/AD5676R evaluation software then opens, as
shown in Figure 5.
Rev. 0 | Page 8 of 12