EVAL-AD5676SDZ Datasheet, PDF (4/12 Pages) Analog Devices – Full featured evaluation board

UG-814
EVAL-AD5676SDZ/EVAL-AD5676RSDZ User Guide
GETTING STARTED
INSTALLING THE SOFTWARE
The evaluation kit for the AD5676/AD5676R includes self-
installing software on the CD. The software is compatible with
Windows® XP, Windows Vista (32-bit), and Windows 7 (32-bit
and 64-bit).
The software must be installed before connecting the SDP-B
board to the USB port of the PC to ensure that the SDP-B board
is recognized when it connects to the PC.
To install the software, take the following steps:
1. Start the Windows operating system and insert the CD.
2. The installation software should open automatically. If it
does not open automatically, run the setup.exe file from
the CD.
3. After installation is complete, power up the evaluation
board as described in the Power Supplies section.
4. Connect the evaluation board to the SDP-B board and
connect the SDP-B board to the PC using the USB cable
included in the kit.
5. When the software detects the evaluation board, proceed
through any dialog boxes that appear to finalize the
installation.
EVALUATION BOARD SETUP PROCEDURES
To set up the evaluation board, take the following steps:
1. Connect the evaluation board to the SDP-B board and
connect the USB cable between the SDP-B board and the PC.
2. Power the SDP-B and evaluation boards by connecting
6 V dc to the J3 connector.
Rev. 0 | Page 4 of 12