ADV7282 Datasheet, PDF (5/32 Pages) Analog Devices – 10-Bit, 4 Oversampled SDTV Video Decoder with Differential Inputs and Deinterlacer

Data Sheet
ADV7282
Parameter
POWER-DOWN CURRENTS¹
Digital I/O Supply Power-Down Current
PLL Supply Power-Down Current
Analog Supply Power-Down Current
Digital Supply Power-Down Current
MIPI Tx Supply Power-Down Current
Total Power Dissipation
in Power-Down Mode
Symbol
IDVDDIO_PD
IPVDD_PD
IAVDD_PD
IDVDD_PD
IMVDD_PD
Test Conditions/Comments
Min
Typ
Max
Unit
73
µA
46
µA
0.2
µA
420
µA
4.5
µA
1
mW
1 _{Guaranteed by characterization.}
2 _{Typical current consumption values are measured with nominal voltage supply levels and an SMPTE bar test pattern.}
3 _{All specifications apply when the I2P core is activated, unless otherwise stated.}
VIDEO SPECIFICATIONS
AVDD, DVDD, PVDD, and MVDD = 1.71 V to 1.89 V, DVDDIO = 2.97 V to 3.63 V, specified at operating temperature range, unless otherwise noted.
Specifications guaranteed by characterization. Note that MVDD only applies to the ADV7282-M.
Table 2.
Parameter
Symbol Test Conditions/Comments
Min
Typ
Max
Unit
NONLINEAR SPECIFICATIONS¹
Differential Phase
DP
CVBS input, modulated 5-step
0.9
Degrees
Differential Gain
DG
CVBS input, modulated 5-step
0.5
%
Luma Nonlinearity
LNL
CVBS input, 5-step
2.0
%
NOISE SPECIFICATIONS
Signal-to-Noise Ratio, Unweighted
SNR
Luma ramp
57.1
dB
Luma flat field
58
dB
Analog Front-End Crosstalk
60
dB
Common-Mode Rejection Ratio²
CMRR
73
dB
LOCK TIME SPECIFICATIONS
Horizontal Lock Range
−5
+5
%
Vertical Lock Range
40
70
Hz
fSC Subcarrier Lock Range
±1.3
kHz
Color Lock-In Time
60
Lines
Synchronization Depth Range
20
200
%
Color Burst Range
5
200
%
Vertical Lock Time
2
Fields
Autodetection Switch Speed³
100
Lines
Fast Switch Speed⁴
100
ms
LUMA SPECIFICATIONS
CVBS, 1 V input
Luma Brightness Accuracy
1
%
Luma Contrast Accuracy
1
%
1 _{These specifications apply for all CVBS input types (NTSC, PAL, and SECAM), as well as for single-ended and differential CVBS inputs.}
2 _{The CMRR of this circuit design is critically dependent on the external resistor matching on the circuit inputs (see the Input Networks section). The CMRR measurement}
was performed with 0.1% tolerant resistors, a common-mode voltage of 1 V, and a common-mode frequency of 10 kHz.
3 _{Autodetection switch speed is the time required for the ADV7282/ADV7282-M to detect which video format is present at its input, for example, PAL I or NTSC M.}
4 _{Fast switch speed is the time required for the ADV7282/ADV7282-M to switch from one analog input (single-ended or differential) to another, for example, switching from}
AIN1 to AIN2.
Rev. A | Page 5 of 32