AD5755_11 Datasheet, PDF(30/48 Page) Analog Devices – Quad Channel, 16-Bit, Serial Input, 4 mA to 20 mA and Voltage Output DAC, Dynamic Power Control

English

English German Russian Spanish Italian Polish Chinese Japanese Korean French Portuguese	Language :

AD5755_11 Datasheet, PDF (30/48 Pages) Analog Devices – Quad Channel, 16-Bit, Serial Input, 4 mA to 20 mA and Voltage Output DAC, Dynamic Power Control

◁

AD5755

REGISTERS

Table 7 shows an overview of the registers for the AD5755.

Table 7. Data, Control, and Readback Registers for the AD5755

Description

Data

DAC Data Register (Ã4)

Used to write a DAC code to each DAC channel. AD5755 data bits = D15 to D0. There are four DAC

data registers, one per DAC Channel.

Gain Register (Ã4)

Used to program gain trim, on a per channel basis. AD5755 data bits = D15 to D0. There are four gain

registers, one per DAC channel.

Offset Register (Ã4)

Used to program offset trim, on a per channel basis. AD5755 data bits = D15 to D0. There are four

offset registers, one per DAC channel.

Clear Code Register (Ã4)

Used to program clear code on a per channel basis. AD5755 data bits = D15 to D0. There are four clear

code registers, one per DAC channel.

Control

Main Control Register

Used to configure the part for main operation. Sets functions such as status readback during write,

enables output on all channels simultaneously, powers on all dc-to-dc converter blocks

simultaneously, and enables and sets conditions of the watchdog timer. See the Device Features

section for more details.

Software Register

Has three functions. Used to perform a reset, to toggle the user bit, and, as part of the watchdog timer

feature, to verify correct data communication operation.

Slew Rate Control Register (Ã4) Use to program the slew rate of the output. There are four slew rate control registers, one per channel.

DAC Control Register (Ã4)

These registers are used to control the following:

Set the output range, for example, 4 mA to 20 mA, 0 V to 10 V.

Set whether an internal/external sense resistor is used.

Enable/disable a channel for CLEAR.

Enable/disable overrange.

Enable/disable internal circuitry on a per channel basis.

Enable/disable output on a per channel basis.

Power on dc-to-dc converters on a per channel basis.

There are four DAC control registers, one per DAC channel.

DC-to-DC Control Register

Use to set the dc-to-dc control parameters. Can control dc-to-dc maximum voltage, phase, and

frequency.

Readback

Status Register

This contains any fault information, as well as a user toggle bit.

Rev. 0 | Page 30 of 48

▷