EVAL-ADG5209FEBZ Datasheet, PDF (3/12 Pages) Analog Devices – Protected against overvoltage on source pins

EVAL-ADG5209FEBZ User Guide
GETTING STARTED
EVALUATION BOARD SETUP PROCEDURE
The EVAL-ADG5209FEBZ evaluation board operates
independently and does not require any additional evaluation
boards or software to operate. An on-board LDO regulator is
provided as the digital power supply to manually control the
ADG5209F.
Supply the evaluation board with a dual power source of up to
±22 V or a single supply of up to +44 V by connecting VSS and
GND together.
UG-875
A functionality test can be set up as follows:
1. Connect a power supply to J5. Connect VSS and GND
together if a single supply is required.
2. Ensure a 0 Ω resistor is inserted in R15 to use the on-board
LDO regulator, and that a 0 Ω resistor is inserted in R14.
3. SW1 through SW3 control the digital signals for the
ADG5209F.
J5
VDD
ADP7142
(LDO)
J1:S1A
J1:S4A
V_DD
ADG5209F
S1A
DA
S4A
R14 = LDO
R13 = EXT_VL
J5
EXT_VL
J5
GND
VSS
SW1
SW2
SW3
J2:S1B
J2:S4B
S1B
DB
S4B
EN
FAULT DETECTION
A0
AND
SWITCH DRIVER
A1
GND ^VSS
Figure 2. EVAL-ADG5209FEBZ Block Diagram
J3:DA
J4:DB
Rev. A | Page 3 of 12