HMC520A Datasheet, PDF (27/28 Pages) Analog Devices – Radio frequency (RF) range: 6 GHz to 10 GHz

Data Sheet
EVALUATION BOARD INFORMATION
The EV1HMC520ALC4 evaluation PCB used in the application
must use RF circuit design techniques. Signal lines must have
50 Ω impedance and connect the package ground leads and
exposed pad directly to the ground plane similarly to that shown
HMC520A
in Figure 84. Use a sufficient number of via holes to connect the
top and bottom ground planes. The evaluation circuit board shown
in Figure 84 is available from Analog Devices, Inc., upon request
Figure 84. EV1HMC520ALC4 Evaluation PCB Top Layer
Table 10. Bill of Materials for the EV1HMC520ALC4 Evaluation PCB
Quantity Reference Designator Description
1
109996-1
PCB, EV1HMC520ALC4
2
J1, J2 (RF, LO)
2.92 mm SMA connectors, SRI Connector Gage
2
J3, J4 (IF1, IF2)
Gold plated SMA, edge mount with 0.02 inch pin connectors, Johnson SMA connectors
1
U1
Device under test, HMC520ALC4
Part Number
109996-1
104935
105192
HMC520ALC4
Page 27 of 28