ADATE206 Datasheet, PDF (11/16 Pages) Analog Devices – 500 MHz Dual DCL

Pin No.
47
48
49
50
51
52
53
54
61
62
63
65
66
67
68
69
70
72
73
74
75
80, 82, 94, 96
81
85
86
88
90
91
95
ADATE206
Mnemonic
DR_EN_N_2
DR_EN_N_T_2
DR_EN_P_T_2
DR_EN_P_2
DR_DATA_N_2
DR_DATA_N_T_2
DR_DATA_P_T_2
DR_DATA_P_2
VTEN_2
LDEN_2
CLLM_2
CLAMPL_2
CLAMPH_2
VIH_2
VIL_2
VIT_2
D_INV_2
VIOL_2
VIOH_2
GNDREF_2
VCOM_2
GND/SHIELDS
DUT_2
CVH_2
CVL_2
TEMP
CVL_1
CVH_1
DUT_1
Description
Complement of DR_EN_P_2.
Complement of DR_EN_P_T_2.
Termination Resistor for HS Inputs. Opposite end of each 50 Ω termination resistor goes to the
appropriate signal.
High Speed Enable Input. Multifunction depending on status of VTEN_2 and LDEN_2. Causes driver
to enter/leave inhibit; driver to enter/leave termination mode; load to leave/enter inhibit
(see Table 4).
Complement of DR_DATA_P_2.
Complement of DR_DATA_P_T_2.
Termination Resistor for HS Inputs. Opposite end of each 50 Ω termination resistor goes to the
appropriate signal.
High Speed Data Input. Sets high/low state of driver output (see Table 4).
Low Speed Control Signal. When high, DR_EN_2 forces driver output to VT; otherwise, DR_EN_2
forces driver to high impedance (see Table 4).
Determines Whether LD Responds to DR_EN_2 or is Disabled (see Table 4).
Comp Low Leakage Mode.
Low Clamp.
High Clamp.
Driver High Voltage Reference.
Driver Low Voltage Reference.
Driver Term Voltage Reference.
Driver Invert.
Program Voltage for IOL (Source).
Program Voltage for IOH (Sink).
Reference GND for VIOL, VIOH.
Commutation Reference Voltage.
Device Ground or Pin Shield.
Output/Input Pin.
Window High Reference Level.
Window Low Reference Level.
Temperature Sense, Five Diode String, Reference to GND.
Window Low Reference Level.
Window High Reference Level.
Output/Input Pin.
Rev. 0 | Page 11 of 16