CM3225R12ML Datasheet, PDF (7/8 Pages) ABC Taiwan Electronics Corp – WOUND CHIP INDUCTOR

SPECIFICATION FOR APPROVAL
REF : 202007008102540-C2-H
PAGE: 7
PROD.
NAME
WOUND CHIP INDUCTOR
ABC'S DWG NO.
ABC'S ITEM NO.
CM3225□□□□L□-□□□
Terminal
strength-pull test
Terminal shall not
be loosened or ruptured
A 0.5kg load shall be applied to both
Terminals in the axis direction for
1 minute
Solderability test
Resistance to
solvent test
The terminal shall
be at least 90%
covered with solder
There shall be no
case deformation
change in
appearance or obliteration
of marking
After fluxing Inductor shall be dipped in
a melted solder bath at 240±5 for
5 seconds
MIL-STD-202F Method 215D
Climatic test
Temperature
characteristic
Humidity test
Cold test
Thermal shock test
Dry heat test
High temperature
load life test
Humidity load life
1 Inductors shall be
no evidence of
electrical and mechanical
damage
2 Inductance shall
not change more
than ±10%
3 Q shall not
change more than ±20%
-40 -- +125
1 Temp 40±2
2 R.H. 90 -- 95%
3 Time 96±2 hours
1 Temp -25±2
2 Time 96±2 hours
Room temp
15 mins
Room temp
15 mins
-40±2
30 mins
+125±2
30 mins
There shall be no
evidence of short or
open circuiting
Total 5 cycles
1 Temp 85±2
2 Time 96±2 hours
1 Temp 85±2
2 Time 1000±12 hours
3 Load Allowed DC current
1 Temp 40±2
2 R.H. 90 -- 95%
3 Time 1000±12 hours
4 Load Allowed DC current
Note
Unless otherwise specified , Allow the specimen to stand at room temperature
for 1 hour or more but not more than 2 hours , Measure the electrical and
mechanical performances
AR-001A