CC45321R0KL Datasheet, PDF (7/8 Pages) ABC Taiwan Electronics Corp – WOUND CHIP INDUCTOR

SPECIFICATION FOR APPROVAL
REF : 20071102-D
PAGE: 7
PROD.
NAME
WOUND CHIP INDUCTOR
ABC'S DWG NO.
ABC'S ITEM NO.
CC4532□□□□L□-□□□
Terminal
strength-pull test
Terminal shall not
be loosened or ruptured
A 0.5kg load shall be applied to both
Terminals in the axis direction for
1 minute﹒
Solderability test
Resistance to
solvent test
The terminal shall
be at least 90%
covered with solder
There shall be no
case deformation
change in
appearance or obliteration
of marking
After fluxing，Inductor shall be dipped in
a melted solder bath at 240±5℃ for
5 seconds﹒
MIL-STD-202F，Method 215D
Climatic test
Temperature
characteristic
Humidity test
Cold test
Thermal shock test
Dry heat test
High temperature
load life test
Humidity load life
1﹒Inductors shall be
no evidence of
electrical and mechanical
damage
2﹒Inductance shall
not change more
than ±10%
3﹒Q shall not
change more than ±20%
There shall be no
evidence of short or
open circuiting
-40℃ -- +125℃
1﹒Temp：40±2℃
2﹒R.H.：90 -- 95%
3﹒Time：96±2 hours
1﹒Temp：-25±2℃
2﹒Time：96±2 hours
Room temp
15 mins
Room temp
15 mins
-40±2℃
30 mins
+125±2℃
30 mins
Total：5 cycles
1﹒Temp：85±2℃
2﹒Time：96±2 hours
1﹒Temp：85±2℃
2﹒Time：1000±12 hours
3﹒Load：Allowed DC current
1﹒Temp：40±2℃
2﹒R.H.：90 -- 95%
3﹒Time：1000±12 hours
4﹒Load：Allowed DC current
Note：
Unless otherwise specified , Allow the specimen to stand at room temperature
for 1 hour or more but not more than 2 hours , Measure the electrical and
mechanical performances
AR-001A