AAT1164 Datasheet, PDF (22/24 Pages) Advanced Analog Technology, Inc. – TRIPLE-CHANNEL TFT LCD POWER SOLUTION

Advanced Analog Technology, Inc.
April 2007
AAT1164/AAT1164B/AAT1164C
Soft Start Waveform
LAYOUT CONSIDERATION
The system’s performances including switching noise,
transient response, and PWM feedback loop stability
supply. The ground connection of the VDD and VREF
bypass capacitor should be connected to the analog
ground pin (GND) with a wide trace.
are greatly affected by the PC board layout and
grounding. There are some general guidelines for
Output Capacitors
Place output capacitors as close as possible to the IC.
layout:
Minimize the length and maximize the width of traces to
Inductor
Always try to use a low EMI inductor with a ferrite core.
get the best transient response and reduce the ripple
noise. We choose 10µF ceramics capacitor to reduce
the ripple voltage, and use 0.1µF ceramics capacitor to
Filter Capacitors
reduce the ripple noise.
Place low ESR ceramics filter capacitors (between
0.1µF and 0.22µF) close to VDD and VREF pins. This
will eliminate as much trace inductance effects as
possible and give the internal IC rail a cleaner voltage
– 台灣類比科技股份有限公司 –
– Advanced Analog Technology, Inc. –
Version 1.00
Page 22 of 24