81068-600C04 Datasheet, PDF (5/8 Pages) 3M Electronics – .050 × .100 Latch/Ejector, PTH & SMT Straight, PTH Right Angle 810 Series

3M^™ 4-Wall, Tripolarized Header
.050" × .100" Latch/Ejector, PTH & SMT Straight, PTH Right Angle
810 Series
∅.025 ± .003
[0.64]
.050 ± .002
[1.27]
.100 ± .002
[2.54]
.025 - .035
[0.64] - [0.89]
*Solder Thief
Solder Pads
(See Note2)
.045 - .060
[1.14] - [1.52]
*Solder Thief Solder Pads required only on
Solder side of PC Board.
View A
Ejector/Latches
None
Long
Short
Table 6
Dimension E (Min)
.215 [5.46]
.650 [16.51]
.525 [13.34]
E
D ± .002
2X .205 ± .003
[5.21]
.050 ± .002 Typ
[1.27]
Tolerance Noncumulative
Flow Solder
Direction
VIEW A
.160 Min
[4.06]
.050 ± .003
[1.27]
.100 ± .002
[2.54]
View A
.225 Min
[5.72]
2X ∅ .109 ± .002
[2.77]
∅.025 ± .003 Typ
[0.64]
.100 ± .002
[2.54]
Recommended Mounting Hole Pattern
PTH Vertical Header
(shown for mounting side of PC Board)
Note:
1. Recommended to process PC Boards through the solder bath such that the connector enters end first
(two solder tails at a time). This will help prevent solder bridging.
2. A Solder Thief Solder Pad (Dummy Pad) at the end of each row is recommended on the bottom or solder side of the PC Board in order to
help prevent solder bridging on the end solder tails. The Solder Thiefs are only required on the end of the rows which leave the solder
bath last.
Inch
[Imm]
Tolerance Unless Noted
.0
.00 .000
Inch ±.1 ±.01 ±.005
[ ] Dimensions for Reference Only
TS-0253-J
Sheet 5 of 7
3
Electronic Solutions Division
Interconnect Solutions
http://www.3Mconnectors.com
3M is a trademark of 3M Company.
For technical, sales or ordering information call
800-225-5373