JNPS-O826C Datasheet, PDF (4/5 Pages) 3M Electronics – 3M brand cnnector for 1.27mm Pitch Flat Cable

JNPS-O826
c
6-3 ELECTRICAL SPECIFICATIONS
TEST
DESCRIPTION
DIELECTRIC
WITHSTANDING
VOLTAGE
INSULATION
RESIDENSE
CONTACT
RESISTANCE
REQUIREMENT
No appearanceof arcing
and break down.
Leak current: lmA Max.
IOOOM.Q Mill.
-Initial/
25 mQ Max.
-Change of contact
resistance after
environmental tests i
20 mQ Max.
TEST CONDlmON
Impressedvoltage is AC IOOOVrms.
between adjacent two contacts for one
minute.
Impressedvoltage is DC SOOVbetween
adjacent two contacts for one minute.
Contact resistanceis measured
at Short Circuit.
Current: 1.5mA
Open Circuit Voltage: 20mV
by 4 terminal method.
* Measurementvalues include
the resistanceof contact pins
as conductive material
* Refer to Table I regarding the conditions
of each environmental test.
RELATED
STANDARD
See Table I
Table ENVIROMENTAL TEST
ITEM
TEST CONDITION
MOISTURE
-10- 65°C, Relative Humidity 95% /10 cycles
SALT SPRAY
NaCI 5% solution, 35°C / 48 hours
THERMAL SHOCK _{-55°C~25°C~85°C~25°C}
/5 cycles
HUMIDITY
(STEADY
STATE)
THERMAL LIFE
40°C, Relative Humidity 95% / 96 hours
Steady Current: Current Rating x 110%, 85°C / 1000 hours
H2S GAS
3 :t 1 ppm, 40°C, Relative Humidity 70 -80% / 96 hours
RELATEDSTANDARD
MlL-Sm-202FIO6D
MIL-STD-202FIOlD
MIL-Sm-202FIO7G
MIL-STD-202FI038
JEIDA-38-1984
7. PLA TING SPEC INDICA TION ON CONNECTOR
The first letter, in stamped3 letters on the connector body for lot numbering, identified the following
plating specs.
~ xx: PR plating
* XX: two alphabet letters
'7