408-8853 Datasheet, PDF (3/3 Pages) TE Connectivity Ltd – Hex Crimping Die

408-8853
DIE
ASSEMBLY
1583696-1
DIE OPENING
±0.10 [±.004]
A
B
C
2.67
[.105]
3.84
[.151]
3.25
[.128]
±0.05 [±.002]
D
0.71
[.028]
Figure 3
5.4. Ratchet Adjustment (Figure 4)
The tool frame assembly ratchet mechanism features
an adjustment wheel with numbered settings. If the
crimp height is not acceptable, adjust the ratchet as
follows:
1. Remove the lockscrew from the ratchet
adjustment wheel.
2. With a screwdriver, adjust the ratchet wheel from
the opposite side of the tool.
3. Observe the ratchet adjustment wheel. If a tighter
crimp is required, rotate the adjustment wheel
COUNTERCLOCKWISE to a higher-numbered
setting. If a looser crimp is required, rotate the
adjustment wheel CLOCKWISE to a lower-
numbered setting.
4. Replace the lockscrew.
5. Make a sample crimp and measure the crimp
height. If the crimp height is acceptable, secure the
lockscrew. If the dimension is unacceptable, remove
lockscrew and continue to adjust the ratchet, and
again measure a sample crimp.
6. REPLACEMENT
Order replacement parts through your TE
representative, or call 1-800-526-5142, or send a
facsimile of your purchase order to 1-717-986-7605, or
write to:
CUSTOMER SERVICE (038-035)
TYCO ELECTRONICS CORPORATION
PO BOX 3608
HARRISBURG PA 17105-3608
7. REVISION SUMMARY
Since the previous release, the new company logo
was applied.
Screwdriver
Ratchet
Adjustment
Wheel
Lockscrew (Typ)
Rev A
Figure 4
3 of 3