RL78L13_15 Datasheet, PDF (1/14 Pages) Renesas Technology Corp – Integrated LCD controller/driver, True Low Power Platform (as low as 112.5 μA/MHz, and 0.61 μA for RTC +LVD), 1.6 V to 5.5 V operation, 16 to 128 Kbyte Flash, 31 DMIPS at 24 MHz, for All LCD Based Applications

Preliminary Datasheet
Specifications in this document are tentative and subject to change.
RL78/L13
R01DS0168EJ0002
RENESAS MCU
Rev.0.02
2012.10.31
Integrated LCD controller/driver, True Low Power Platform (as low as 112.5 µA/MHz, and 0.61 µA for RTC +
LVD), 1.6 V to 5.5 V operation, 16 to 128 Kbyte Flash, 31 DMIPS at 24 MHz, for All LCD Based Applications
1. OUTLINE
1.1 Features
Ultra-Low Power Technology
• 1.6 V to 5.5 V operation from a single supply
• Stop (RAM retained): 0.25 µA, (LVD enabled): 0.33 µA
• Halt (RTC + LVD): 0.61 µA
• Supports snooze
• Operating: 112.5 µA/MHz
• LCD operating current (Capacitor split method): 0.29
µA
• LCD operating current (Internal voltage boost
method): 0.68 µA
16-bit RL78 CPU Core
• Delivers 31 DMIPS at maximum operating frequency
of 24 MHz
• Instruction Execution: 86% of instructions can be
executed in 1 to 2 clock cycles
• CISC Architecture (Harvard) with 3-stage pipeline
• Multiply Signed & Unsigned: 16 x 16 to 32-bit result in
1 clock cycle
• MAC: 16 x 16 to 32-bit result in 2 clock cycles
• 16-bit barrel shifter for shift & rotate in 1 clock cycle
• 1-wire on-chip debug function
Code Flash Memory
• Density: 16 KB to 128 KB
• Block size: 1 KB
• On-chip single voltage flash memory with protection
from block erase/writing
• Self-programming with secure boot swap function
and flash shield window function
Data Flash Memory
• Data Flash with background operation
• Data flash size: 4 KB
• Erase Cycles: 1 Million (typ.)
• Erase/programming voltage: 1.8 V to 5.5 V
RAM
• 1 KB to 8 KB size options
• Supports operands or instructions
• Back-up retention in all modes
High-speed On-chip Oscillator
• 24 MHz with +/− 1% accuracy over voltage (1.8 V to
5.5 V) and temperature (−20 °C to +85 °C)
• Pre-configured settings: 48 MHz, 24 MHz, 16 MHz,
12 MHz, 8 MHz, 4 MHz & 1 MHz (TYP.)
<R> _{Reset and Supply Management}
• Power-on reset (POR) monitor/generator
• Low voltage detection (LVD) with 14 setting options
(Interrupt and/or reset function)
LCD Controller/Driver
<R> • Up to 51 seg x 4 com or 48 seg x 8 com
R01DS0168EJ0002 Rev.0.02
2012.10.31
• Supports capacitor split method, internal voltage
boost method and resistance division method
• Supports waveform types A and B
• Supports LCD contrast adjustment (18 steps)
• Supports LCD blinking
Data Memory Access (DMA) Controller
• Up to 4 fully programmable channels
• Transfer unit: 8- or 16-bit
Multiple Communication Interfaces
• Up to 2 x I²C master
• Up to 1 x I²C multi-master
• Up to 2 x CSI (7-, 8-bit)
• Up to 4 x UART (7-, 8-, 9-bit)
• Up to 1 x LIN
Extended-Function Timers
• Multi-function 16-bit timer TAU: Up to 8 channels
(remote control output available)
• Multi-function 16-bit timer KB20: 1 channel
• High accuracy real-time clock (RTC005): 1 channel
(full calendar and alarm function with watch
correction function)
• 12-bit interval timer: 1 channel
• 15 kHz watchdog timer: 1 channel (window function)
Rich Analog
• ADC: Up to 12 channels, 8/10-bit resolution, 2.1 µs
minimum conversion time
• Supports 1.6 V
• Internal voltage reference (1.45 V)
• On-chip temperature sensor
Safety Features (IEC or UL 60730 compliance)
• Flash memory CRC calculation
• RAM parity error check
• RAM write protection
• SFR write protection
• Illegal memory access detection
• Clock stop/ frequency detection
• ADC self-test
• I/O port read back function (echo)
General Purpose I/O
• 5 V tolerant, high-current (up to 20 mA per pin)
• Open-Drain, Internal Pull-up support
Operating Ambient Temperature
• Consumer application: −40°C to + 85°C
• Industrial application: −40°C to + 105°C
Package Type and Pin Count
• 64-pin plastic LQFP (fine pitch) (10 x 10)
• 64-pin plastic LQFP (12 x 12)
• 80-pin plastic LQFP (fine pitch) (12 x 12)
• 80-pin plastic LQFP (14 x 14)
Page 1 of 11