409-2426 Datasheet, PDF (8/17 Pages) Tyco Electronics – Pneumatic Tools

Pneumatic Tools 68068 and 68068-1
Installing Jaw Assembly
409-2426
Tool 68068 Shown
Pivot Pin
Holes
Cam
Jaw Assembly
(Ref)
Locator (Ref)
Jaw Cam Rollers
Pivot Pins
Cowling
Pin
Figure 6
Lower Housing Cover
Retaining
Pin
4. OPERATING PROCEDURE
Make sure to follow safety precautions (refer to Paragraph 1.4) before and during operation of the tool. Refer to
the instructions included with the jaw assembly for specific wire preparation and crimp inspection requirements.
DANGER
To avoid personal injury, ALWAYS keep fingers clear of the jaw closure during crimping cycles.
1. Connect the tool to the air supply according to Paragraph 1.2, and check the air pressure according to
Paragraph 1.3.
2. Insert the wire into the wire barrel of the terminal or splice.
3. Place the terminal or splice in the lower jaw (refer to the instructions included with the jaw assembly
for specific location in the jaw).
4. FULLY depress the tool control button (the jaws will close).
5. Release the tool control button to open the jaws, then remove the crimped terminal or splice.
8 of 17
Tyco Electronics Corporation
Rev A