SW90-0004A Datasheet, PDF (1/4 Pages) Tyco Electronics – GaAs SP6T Switch, Absorptive, Single Supply DC - 4.0 GHz

GaAs SP6T Switch, Absorptive, Single Supply
DC - 4.0 GHz
SW90-0004A
V7
Features
• Operates DC - 4 GHz on Single Supply
• ASIC TTL / CMOS Driver
• Leadless 4 x 7 mm Chip Scale Plastic Package
• Low DC Power Consumption
• 50 Ohm Nominal Impedance
• Test Boards are Available
• Tape and Reel are Available
Description
M/A-COM's SW90-0004A is a SP6T absorptive
pHEMT switch with integral TTL driver. This device
is in an MLP plastic surface mount package. This
switch offers excellent broadband performance and
repeatability from DC to 4 GHz, while maintaining
low DC power dissipation. The SW90-0004A is
ideally suited for wireless infrastructure applications.
Ordering Information
Part Number
SW90-0004A
SW90-0004ATR
SW90-0004A-TB
Package
Bulk Packaging
1000 piece reel
Units Mounted on Test Board
Note: Reference Application Note M513 for reel size
information.
Absolute Maximum Ratings ^1,2
Parameter
Max. Input Power
0.05 GHz
0.5 - 4.0 GHz
Bias Voltages
V_CC
Control Voltage ³
Operating Temperature
Storage Temperature
Absolute Maximum
+27 dBm
+34 dBm
+5.5V
-0.5V to V_CC +0.5V
-40°C to +85°C
-65°C to +125°C
1. Operation of this device above any one of these parameters
may cause permanent damage.
2. When the RF input is applied to the terminated port, the
absolute maximum power is +30 dBm.
3. Standard CMOS TTL interface, latch-up will occur if logic
signal is applied prior to power supply.
Functional Schematic
Pin Configuration ^4,5,6
Pin No.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
Function
CP2
V_EE
NC
C6
C5
C4
C3
C2
C1
NC
GND
NC
GND
RF1
GND
RF2
GND
RF3
Pin No.
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
Function
GND
NC
GND
RFC
GND
GND
RF4
GND
RF5
GND
RF6
GND
NC
V_EE
Vcc
NC
Vcc
CP1
4. NC = No Connection
5. For single supply operation VEE is internally generated and
must remain isolated from external power supplies.
Generated noise is typical of switching DC-DC Converters.
6. Connections and external components shown in functional
schematic are required. 0.1µF Capacitors need to be located
near pins 32 & 33.
1
M/A-COM Inc. and its affiliates reserve the right to make changes to the
product(s) or information contained herein without notice. M/A-COM makes
no warranty, representation or guarantee regarding the suitability of its
products for any particular purpose, nor does M/A-COM assume any liability
whatsoever arising out of the use or application of any product(s) or
information.
• North America Tel: [phone] / Fax: [phone]
• Europe Tel: [phone] / Fax: [phone]
• Asia/Pacific Tel: [phone] / Fax: [phone]
Visit www.macom.com for additional data sheets and product information.