N1014A Datasheet, PDF (4/9 Pages) Keysight Technologies – Compliance and Debug Application

04 | Keysight N1014A SFF-8431 Compliance and Debug Application for 86100D DCA-X Oscilloscopes - Data Sheet
Debug and Verify Your Designs Quickly and Easily
Select Industry-Leading Hardware
Configure your oscilloscope for a single module (as below) or
multi-module (listed in ordering guide). Connect your device
through the recommended phase trimmers to have access to
measurements with intrinsic jitter as low as 50 fs. For return
loss, also connect the Economy or Performance Network
Analyzer, which are controlled by the DCA-X for S-parameter
measurements.
Configure Your Measurements
Customize parameters that are specific to your setup, such
as data rate and attenuation. Use default values or enter
your own settings including number of waveforms or patterns
taken; type of pattern; and whether or not to remove the
effects of test cables. Choose Normal mode to test within
compliance limits or choose Debug mode to test to your
custom limits and adjust other test parameters.
Select Any SFP+ Transmit Interface
The N1014A SFF-8431 Compliance and Debug Application
covers all host and module transmitter tests as well as
verification of the test signals for receiver compliance. Click
on the desired test group, and the appropriate tests are
offered in Select Tests.
Choose from More Than 70 Tests
The tests required for each of the transmit and test signal
groups are available. You can click on all tests, a group of
tests or individual tests. The full test name appears in the test
list and is shown in the test results and reports. A description
of the test and reference to the SFF-8431 Specifications
are shown for each test. You may also measure TWDP by
interfacing with your MATLAB script.