SX493 Datasheet, PDF (1/2 Pages) List of Unclassifed Manufacturers – Photomicrosensor

EE-SX493
Photomicrosensor
(Transmissive)
Dimensions
Note: All units are in millimeters unless otherwise indicated.
6
0.2
Features
• Incorporates an IC chip with a built-in detector element and
amplifier.
• Incorporates a detector element with a built-in temperature
compensation circuit.
• A wide supply voltage range: 4.5 to 16 VDC
• Directly connects with C-MOS and TTL.
• Allows highly precise sensing with a 0.2-mm-wide sensing
aperture.
9.5
(1.25)
(1.25)
6.5±0.05
6.9±0.5
Five, 0.25 ^{Five, 0.5}
Pull-off
taper:
1/25
max.
Absolute Maximum Ratings
(Ta = 25°C)
Item
Symbol
Rated
value
Cross section AA
0.75±0.1 ^Emitter
Cross section BB
Forward current I_F
Reverse voltage V_R
50 mA
(see note 1)
4V
Internal Circuit
7±0.1
Two,
1
0
–0.2
dia.
(Tip
dimension)
Detector
Power supply voltage
Output voltage
V_CC
V_OUT
16 V
28 V
K
V
Output current I_OUT
16 mA
O
A
G
Terminal No.
A
K
V
O
Name
Anode
Cathode
Power supply
(Vcc)
Output (OUT)
Unless otherwise specified, the
tolerances are as shown below.
Dimensions
3 mm max.
3 t mm v 6
6 t mm v 10
10 t mm v 18
Tolerance
±0.125
±0.150
±0.180
±0.215
Permissible output
dissipation
P_OUT
250 mW
(see note 1)
Ambient
Operating
temperature
Topr
–40°C to
60°C
Storage
Tstg
–40°C to
85°C
Soldering temperature
Tsol
260°C
(see note 2)
Note: 1. Refer to the temperature rating chart if the ambient
temperature exceeds 25°C.
G
Ground (GND)
18 t mm v 30
±0.260
2. Complete soldering within 10 seconds.
Electrical and Optical Characteristics (Ta = 25°C)
Item
Emitter Forward voltage
Reverse current
Peak emission
wavelength
Detector Low-level output
voltage
High-level output
voltage
Current consumption
Peak spectral
sensitivity wavelength
LED current when output is OFF
LED current when output is ON
Hysteresis
Response frequency
Symbol
V_F
I_R
λ_P
V_OL
V_OH
I_CC
λ_P
I_FT
nH
f
Value
1.2 V typ., 1.5 V max.
0.01 µA typ., 10 µA max.
940 nm typ.
0.12 V typ., 0.4 V max.
15 V min.
5 mA typ., 10 mA max.
870 nm typ.
10 mA typ., 15 mA max.
15% typ.
3 kHz min.
Response delay time
Response delay time
t_PLH (t_PHL) 3 µs typ.
t_PHL (t_PLH) 20 µs typ.
I_F = 20 mA
V_R = 4 V
I_F = 20 mA
Condition
Vcc = 4.5 to 16 V, I_OL = 16 mA, I_F = 15 mA
Vcc = 16 V, R_L = 1 kΩ, I_F = 0 mA
Vcc = 16 V
V_CC = 4.5 to 16 V
V_CC = 4.5 to 16 V
V_CC = 4.5 to 16 V (see note 1)
V_CC = 4.5 to 16 V, I_F = 15 mA, I_OL = 16 mA
(see note 2)
V_CC = 4.5 to 16 V, I_F = 15 mA, I_OL = 16 mA
(see note 3)
V_CC = 4.5 to 16 V, I_F = 15 mA, I_OL = 16 mA
(see note 3)
168