Z89C6501ZEM Datasheet, PDF (6/6 Pages) Zilog, Inc. – ICEBOX FAMILY Z8 IN-CIRCUIT EMULATOR -C65

PRECAUTION LIST
1. All Z8 control registers are write only unless stated
otherwise.
2. Power Supply ramp-up/rise time must be such that
when minimum power-on reset time (T_POR) expires,
then the V must be in the supported specified
CC
operating range of the device.
3. Check the T and T specifications of the device
POR
WDT
that you wish to emulate. The actual specification may
differ from the ICE chip specifications.
4. The general-purpose registers after Power-On Reset
or at initial emulator use will be different than the actual
device. The emulator self test will always leave the
same values in the general-purpose registers, while
the real device will have a random/undefined value in
the general-purpose registers.
Z89C6501ZEM
CP96TAD00403
5. The Emulator cannot be operated while performing
ESD/EMI testing on the target board.
6. GUI software versions prior to 3.00 are incompatible
with hardware containing BOOTROM 3.00. The GUI
software may still boot, but will fail at some later point
of the session.
7. The status color bar in OTP dialog box will be cleared
in the area where a new window opens on top of it.
8. For 386 PCs, set the baud rate to 19.2K or less
because Windows’ communication driver does not
guarantee “reliable” operation at more than 9600
baud. Selecting a high baud rate on some slower 386
machines may crash the Windows environment.
9. If DSP programs and Z8 programs are to be executed
concurrently, the DSP program must be started first,
then the Z8 program.
© 1996 by Zilog, Inc. All rights reserved. No part of this document
may be copied or reproduced in any form or by any means
without the prior written consent of Zilog, Inc. The information in
this document is subject to change without notice. Devices sold
by Zilog, Inc. are covered by warranty and patent indemnification
provisions appearing in Zilog, Inc. Terms and Conditions of Sale
only. Zilog, Inc. makes no warranty, express, statutory, implied or
by description, regarding the information set forth herein or
regarding the freedom of the described devices from intellectual
property infringement. Zilog, Inc. makes no warranty of mer-
chantability or fitness for any purpose. Zilog, Inc. shall not be
responsible for any errors that may appear in this document.
Zilog, Inc. makes no commitment to update or keep current the
information contained in this document.
Zilog’s products are not authorized for use as critical compo-
nents in life support devices or systems unless a specific written
agreement pertaining to such intended use is executed between
the customer and Zilog prior to use. Life support devices or
systems are those which are intended for surgical implantation
into the body, or which sustains life whose failure to perform,
when properly used in accordance with instructions for use
provided in the labeling, can be reasonably expected to result in
significant injury to the user.
Zilog, Inc. 210 East Hacienda Ave.
Campbell, CA 95008-6600
Telephone [phone]
Telex 910-338-7621
FAX [phone]
Internet: http://www.zilog.com
6