Z86317 Datasheet, PDF (4/8 Pages) Zilog, Inc. – CMOS Z8 8-BIT MICROCONTROLLER

PRELIMINARY
STANDARD TEST CONDITIONS
The characteristics listed below apply for standard test
conditions as noted. All voltages are referenced to Ground.
Positive current flows into the referenced pin (Figure 3).
From Output
Under Test
Z86317
CMOS Z8^® 8-BIT MCU
I
150 pF
Figure 3. Test Load Diagram
ABSOLUTE MAXIMUM RATINGS
Sym Parameter
Min
V_DD
T_STG
T_A
Supply Voltage*
Storage Temp
Oper Ambient Temp
–0.3
–65°
†
Notes:
* Voltages on all pins with respect to Ground.
† See Ordering Information.
Max Units
+7
V
+150° C
†
C
Stresses greater than those listed under Absolute Maxi-
mum Ratings may cause permanent damage to the de-
vice. This is a stress rating only; operation of the device at
any condition above those indicated in the operational
sections of these specifications is not implied. Exposure to
absolute maximum rating conditions for extended periods
may affect device reliability.
CAPACITANCE
T_A = GND = 0V, f = 1.0 MHz, unmeasured pins returned to Ground.
Parameter
Min
Input Capacitance
0
Output Capacitance
0
I/O Capacitance
0
Max
10 pF
20 pF
25 pF
V_CC SPECIFICATION
V_CC = 4.5V to 5.5V
When using the precision RC oscillator feature
f = 4.0 MHz ± 10% under the following conditions:
s V_CC = 5.0V ± 10%
s Temp 0 to 40°C
s Application board capacitance: 2.0 pF max.
0.5 pF min.
4
DS96KEY1102