ZCRMZNICE01ZACG Datasheet, PDF (2/4 Pages) Zilog, Inc. – 20-SSOP programming adapter

ZCRMZNICE01ZACG 20-Pin Accessory Kit
To connect a 20-PDIP target board to the Crimzon ICE:
1. Install the 20-PDIP target pod into the 20-PDIP socket on your target board.
2. Connect the 34-circuit ribbon cable included with the Crimzon ICE from P10 on the
ICE to P1 on the target pod.
3. Set the jumper on the 20-PDIP target pod as described in Table 1.
Table 1. Jumper Settings on the 20-PDIP Target Pod
Jumper
J1 ON
J1 OFF
Function
Infrared (IR)
Amplifier
Digital/Analog
20-SSOP, 20-SOIC, and 20-PDIP Programming Adapters
The programming adapters enable you to program 20-pin OTP devices using the OTP pro-
gramming module supplied with the Crimzon ICE. The 20-SSOP adapter is shown in Fig-
ure 2. To use the adapter:
1. Install the 20-pin device into the appropriate programming adapter.
2. Install the programming adapter into the ZIF socked on the OTP programming
module (see Figure 3).
Refer to the Crimzon ICE User Manual, UM0217, for details on using the Crimzon ICE
and OTP programming module.
PUG002801-0108
Figure 2. 20-SSOP Programming Adapter
Page 2 of 4