Z89C6700ZEM Datasheet, PDF (2/6 Pages) Zilog, Inc. – Z8 GUI Emulator Software

HOST COMPUTER
Minimum Requirements
IBM PC (or 100-percent compatible) 386-based
machine
33 MHz
4 MB RAM
VGA Video Adapter
Hard Disk Drive (1 MB free space)
3.5-inch, High-Density (HD) Floppy Disk Drive
RS-232C COM port
Mouse or Pointing Device
Microsoft Windows 3.1
Documentation
Emulator User Manual
Z8 Cross-Assembler User's Guide
Universal Object File Utilities (MOBJ)
Registration Card
LIMITATIONS
Z89C6700ZEM
CP95TAD0504
1. Changing drives in file download and load symbol
dialog boxes is not anticipated by the GUI. Typing in
the filename in a directory other than shown in “Path:”
will result in “File not found”. Changing the drive using
the mouse is the workaround.
The following changes to the Minimum Requirements are
recommended for increased performance:
486- or Pentium-based machine
66 MHz (or faster)
8 MB of RAM (or more)
SVGA Video Adapter
Color Monitor
Printer
KIT CONTENTS
2. The initial blue Zilog screen will be distorted by other
active windows. This only affects the appearance, not
functionality, of the GUI.
3. Switching ICEBOXes without quitting the GUI is not
supported.
4. The maximum symbols that can be loaded is 32768,
provided that there is enough system resource
(memory).
Z89C67 Emulator
•Emulation Base Board includes:
CMOS Z86C9320PSC
8K x 8 EPROM (Programmed with Debug Monitor)
32K x 8 Static RAM
Three 64K x 4 Static RAM
RS-232C Interface
Reset Switch
•Z89C67 Emulation Daughterboard
Z86C5020GSE ICE Chip
Two 3K x 8 Static RAM
Two 100-Pin HP-16500 Logic Analysis System
Interface Connectors
Z89C0010GSC
80/80-Pin Target Connectors
5. The ICEBOX breakpoint hardware does not distinguish
between instruction and data fetches. When a
breakpoint in the GUI is set, the breakpoint hardware
triggers when the addresses match for either code or
data fetches.
Example:
000C
000E
0010
0012
0013
0016
SRP
LD
LD
NOP
JP
NOP
#%0
R4, #%0016
R5, @R4
%000C
Setting the breakpoint at %0016 and click GO.
Cables/Pods
Power Cable with Banana Plugs
DB25 RS-232C Cable
84-Pin PLCC Emulation Pod Cable
Host Software
Z8^® GUI Emulator Software
ZASM Cross-Assembler/ MOBJ Object File Utilities
Miscellaneous
20-Pin DIP Jumper Block
Result: The code will break and stop at %0012.
Note: This will not happen when Animate Mode is on
because the GUI is not using the hardware breakpoints
when in Animate Mode.
6. If the emulator is running a user code at full speed and
the port window is opened: Switching to another
application or minimizing the GUI (then restoring) will
result in the following ICEBOX Communications Error
message: “Emulator rejected command: target
program is executing.” This message may need to be
cleared several times (as many as seven) before the
GUI returns to normal operation.
2