ZLP12800100ZACG Datasheet, PDF (1/5 Pages) Zilog, Inc. – Crimzon development board with no silicon installed

ZLP12800100ZACG
Crimzon™
Development Board
Accessory Kit
PUG002401-0806
Product User Guide
Introduction
Thank you for purchasing the ZiLOG ZLP12800100ZACG Crimzon^TM Development
Board Accessory Kit (Figure 1). The Crimzon^TM Development Board Accessory Kit is
designed for use as a target with the Crimzon™ In-Circuit Emulator
(ZLP128ICE01ZEMG). The kit is powered by two 1.5V AAA batteries.
The board can also be powered using an adjustable DC power supply connected between
terminals J7 (VBAT) and J6 (GND).
This startup guide tells you how to install the batteries supplied with the accessory kit and
how to verify proper development board operation.
Kit Contents
• One (1) Crimzon development board with no silicon installed
• Two (2) 1.5V AAA batteries
Applying Power to the Kit
To apply power to the development kit:
1. Install the two (2) AAA batteries in the battery holder on the bottom of the
development board. When installing the batteries, ensure that the batteries are fully
seated in the battery holder by rotating each battery after snapping it into place.
2. Set the On-Off switch (Figure 1) to the ON position.
Refer to the Crimzon In-Circuit Emulator User Manual, UM0184, for details using the
development board accessory kit to develop IR applications.
ZiLOG Worldwide Headquarters • 532 Race Street • San Jose, CA 95126
Telephone: [phone] • Fax: [phone] • www.ZiLOG.com