ZGP323ICE15ZEM Datasheet, PDF (1/25 Pages) –

ZGP323ICE15ZEM
Z8 GP™ ZGP323 In-Circuit Emulator
and Development Platform
User Manual
UM019302-0407
Introduction
Thank you for purchasing the ZiLOG Z8 GP In-Circuit Emulator (ICE) and Development
Platform, ZGP323ICE15ZEM. The Z8 GP ICE provides Z8 GP family chip emulation
with a trace and event system for program debugging using ZDS II development tools.
Once your code is complete, use the included OTP programming module to burn your
design to OTP devices.
This startup guide tells you how to:
1. Install ZDS II software.
2. Configure the Z8 GP ICE for connection to your PC.
Note: The kit includes 20-PDIP and 28-PDIP target PODs and programming adapt-
ers. Target PODs and adapter support for other packages must be ordered sep-
arately. See section “Adapter Kit Ordering Information” on page 23 for
details.
3. Use a target POD to connect the Z8 GP ICE to a target board such as the Z8 GP
ZGP323 evaluation board (included) with a 20-, 28-, or 40-PDIP socket. (Converters
for 20- and 28-SOIC and 20-, 28-, and 48-SSOP sockets are available in the adapter
kits described on page 23.)
4. Connect the Z8 GP ICE to a supplied OTP programming module.
5. Use the supplied OTP programming module with ZDS II software to program a 20-,
28-, or 40-PDIP Z8 GP family device. (Adapters for 20- and 28-SOIC and for 20-, 28-
and 48-SSOP packages are available in the adapter kits described on page 23.)
6. Run a demonstration program to verify proper operation, illustrate basic operation of
the trace and event system, and burn a Z8 GP OTP device using the OTP program-
ming module.
Software Requirements
Table 1 lists the PC requirements for running ZDS II.
Copyright © 2007 by ZiLOG, Inc. All rights reserved.
www.zilog.com